Advertisement
Quick Links
FREESTANDING
WATER CHILLER
Installation & Maintenance Instructions
DFSA120
FREE STANDING BUBBLER
AND CARAFE FILLER - POWDER COATED
DFSA121
FREE STANDING BUBBLER
AND CARAFE FILLER - STAINLESS
I00026_Sep 20
Call 1300 369 273
www.enware.com.au
Enware Australia Pty Limited
9 Endeavour Rd Caringbah NSW 2229 Australia
Ph: 02 8536 4000 info
enware.com.au
@
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for enware DFSA120
Summary of Contents for enware DFSA120
- Page 1 FREE STANDING BUBBLER AND CARAFE FILLER - POWDER COATED DFSA121 FREE STANDING BUBBLER AND CARAFE FILLER - STAINLESS I00026_Sep 20 Call 1300 369 273 www.enware.com.au Enware Australia Pty Limited 9 Endeavour Rd Caringbah NSW 2229 Australia Ph: 02 8536 4000 info enware.com.au...
- Page 2 * Suitable for use in ambient temperatures of 10°C to 32°C * Suitable for use in ambient temperatures of 10°C to 32°C Enware products are to be installed in accordance with the Plumbing Code of Australia Enware products are to be installed in accordance with the Plumbing Code and AS/NZS3500.
- Page 3 SLIDE HANDLE ON 1. Align the brass adjusting nut so that it sits crosswise. SEE IMAGE 3 POSITIONED FROM THIS SIDE CROSS-WISE 2. From the tapered end of the handle, start to slide the handle on to the nut, making sure the adjusting nut stays in the crosswise direction. SEE IMAGE 4 3. Slide the handle all the way until it clicks into place. 4. Insert spout into the spout hole. Screw the spout all the way in until it comes to a stop, then wind back to the desired spout position. SEE IMAGE 5 5. Turn water supply on and check for leaks. 6. Test the handle by pressing it down. If the handle is too tight or too loose, turn water IMAGE 4 IMAGE 5 supply off, go back to step 1 and adjust the nut up or down to achieve correct fit. If the handle is fit too tight, water may not shut off properly and may constantly run or drip from the spout. To loosen, unscrew nut (up). To tighten, screw the nut in (down). Go back to step 1. www.enware.com.au Call 1300 369 273...
- Page 4 Some lines CLEANING contain gas under high pressure. • Keep ventilation openings, in the appliance enclosure or in Enware Product should be cleaned with a soft damp cloth using the built-in structure, clear of obstruction. only mild liquid detergent or soap and water. Do not use cleaning • Do not use mechanical devices or other means to accelerate agents containing a corrosive acid, scouring agent or solvent the defrosting process, other than those recommended by chemicals. Do not use cream cleaners, as they are abrasive. Epoxy...
Need help?
Do you have a question about the DFSA120 and is the answer not in the manual?
Questions and answers