Download Print this page

Technical Data; Installation; Water Connection - Electrolux ESL63010 User Manual

Hide thumbs


Table of Contents
16 electrolux
Dry water drop signs on
glasses and dishes


Electrical connection - Voltage -
Overall power - Fuse
Water supply pressure


Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Important! Obey the instructions in the
enclosed template to:
• Build-in the appliance.
• Install the furniture panel.
• Connect to the water supply and drain.
Install the appliance under a counter (kitch-
en worktop or sink).
If a repair is necessary, the appliance must
be easily accessible for the engineer.
Put the appliance adjacent to a water tap
and a drain.
For the venting of the dishwasher only wa-
ter fill, water drain and power supply cable
openings are necessary.
The dishwasher has adjustable feet to allow
the adjustment of the height.


Water inlet hose
Connected the appliance to a hot (max.
60°) or cold water supply.
If the hot water comes from alternative
sources of energy that are more environ-
mentally friendly (e.g. solar or photovoltaic
panels and aeolian), use a hot water supply
to decrease energy consumption.
Connect the inlet hose to a water tap with
an external thread of 3/4".
The cleaning results are not satisfactory
• Increase rinse aid dosage.
• The detergent can be the cause.
Width cm
Height cm
Depth cm
Information on the electrical connection is given on the rating
plate on the inner edge of the dishwasher door.
Place settings
Make sure that the water inlet hose, the
drain hose and the supply cable are not
kinked or squashed, when you insert the
Attaching the appliance to the adjacent
Make sure that the counter below which
you attach the appliance is a safe structure
(adjacent kitchen units, cabinets, wall).
Adjusting the level of the appliance
Make sure that the appliance is level to
close and seal the door correctly. If the level
of the appliance is correct, the door does
not catch on the sides of the cabinet. If the
door does not close correctly, loosen or
tighten the adjustable feet until the appli-
ance is level.
Caution! Do not use connection hoses
from an old appliance.
The water pressure must be in the limits (re-
fer to 'Technical data'). Make sure that the
local water authority gives you the average
mains pressure in your area.
Make sure that there are no kinks in the
water inlet hose and that the water inlet
hose is not squashed or entangled.
Fit the locknut correctly to prevent water
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)


Table of Contents

  Also See for Electrolux ESL63010

  Related Manuals for Electrolux ESL63010