Operation; Troubleshooting - Honeywell PEHA 450 FU-SP 2 Installation And Operating Instructions Manual

OPerAtiOn

The transmitter board can be used to simulate wall
transmitters. The first transmitter could, for exam-
ple, turn a light ON/OFF. The second transmitter
could move a shutter UP/DOWN.
Button O
Button l
Button 
Button 
example of two-button operation:
transmitter board
trans-
yellow = OFF/UP
mitter 1 white = ON/DOWN
trans- red = OFF/UP
mitter 2 grey = ON/DOWN
note: Transmitter 1 or transmitter 2 must be used
as a pair of buttons for two-button operation.
training transmitters to a receiver:
receiver train transmitter
Activate receiver Activate transmitter 1x by
learn mode. If neces- pressing the button on the
sary, set the functions series switch once in order
and parameters for to train transmitter 1 or 2
the radio receiver to the receiver.
(see receiver instruc-
caution!
tions).
The transmitter is alter-
nately trained to the re-
ceiver or deleted each time
the button is pressed.

trOuBLeshOOting

new systeM Or existing systeM
• Check circuit breaker and power supply
caution: Electrician only!
• Check connected electrical loads and connection
cables caution: Electrician only!
• Check the system's surroundings for changes that
could cause interference (e.g. metal cabinets,
furniture or walls which have been moved).
• If the transmitter/receiver operates at a reduced
distance, the radio signal was encountering
interference or it was operating outside the
transmission range.
• Use the device at a better location.
• Delete all transmitters and reprogramme the
receiver.
receiVer switches By itseLF
• This may be caused by operation of an external
transmitter
that was coincidentally assigned to the receiver.
• Delete all transmitters and reprogramme the
receiver.
rADiO signAL rAnge LiMitAtiOns
• Use of the device in the vicinity of metal objects or
materials with metal components.
note: Maintain a distance of at least 10 cm.
• Moist materials.
• Devices which emit high-frequency signals
(e.g. audio and video systems, computers,
electronic ballasts).
note: Maintain a distance of at least 0.5 m.
cOntAct
Telephone: ............ +49 (0)2351 185-0
Telefax: ................. +49 (0)2351 27666
Internet: ............... www.peha.de
E-Mail: .................. peha@peha.de
PEHA_M_450 FU-SP2 (Rev02_130516)
cOrrect BAttery DisPOsAL
If the battery is marked with the chemical symbols
Hg, Cd or PB, the mercury, cadmium or lead con-
tent of the battery is above the limits stipulated by
EC Directive 2006/66. Incorrect battery disposal
can cause damage to human health and the envi-
ronment. End-of-life batteries must be disposed of
separately; they can be deposited free of charge
with dealers or municipal collection points.
generAL inFOrMAtiOn
wall transmitter
Button O = OFF
DisPOsAL OF the DeVice
Button l = ON
Button  = UP
Button  = D OWN
The device contains electrical components that
must be disposed of as electronics waste. The en-
closure is made from recyclable plastic.
wArrAnty cOnDitiOns
These operating instructions are an integral part of
both the device and our terms of warranty. They
must be handed over to the user. The technical de-
sign of the appliance is subject to change without
prior notification. PehA products are manufactured
and quality-checked with the latest technology ac-
cording to applicable national and international reg-
ulations. Nevertheless, if a product should exhibit a
defect, PehA warrants to make remedy as follows
(regardless of any claims against the dealer to which
the end user may be entitled as a result of the sales
transaction):
In the event of a justified and properly established
claim, PehA shall exercise its prerogative to either
repair or replace the defective device. Further claims
or liability for consequential damage are explicitly
excluded. A justifiable deficiency is deemed to exist
if the device exhibits a structural, manufacturing, or
material defect that makes it unusable or substan-
tially impairs its utility at the time it is turned over to
the end user. The warranty does not apply to natu-
ral wear, improper usage, incorrect connection, de-
vice tampering or the effects of external influences.
The warranty period is 24 months from the date of
purchase by the end user from a dealer and ends
not later than 36 months after the device's date of
manufacture. German law shall be applicable for the
settlement of warranty claims.
cOnFOrMity DecLArAtiOn
PEHA products may be sold and operated in EU
countries as well as in CH, IS and N. PEHA herewith
declares that the transmitter board (450 FU-SP 2)
is in compliance with the fundamental requirements
and other relevant provisions of R&TTE Directive
1999/5/EC. The conformity declaration is avail-
able on the Internet at the following address: www.
peha.de.
Postfach 1727 • D-58467 Lüdenscheid • Internet: www.peha.de
126537-01
the iD code on the battery and in the
documentation indicates that the bat-
tery must not be disposed of together
with normal household waste.
Do not dispose of old devices in the house-
hold waste! The device must be disposed of
in compliance with the laws and standards
of the country in which it is operated!
PEHA Elektro GmbH & Co. KG
gB-2