Advertisement
Table of Contents
Sanification mode
When the exhaust filter led turns on, it is time to replace the filter cartridge:
Turn unit off through main on/off switch (Fig. 14).
1.
Pull unit from cabinet (Fig. 6) and look for valve near the
2.
CO
cylinder.
2
Close valve (Fig. 18).
3.
Position under the water dispense nozzle a container and
4.
dispense water to empty filter cartridge and tubes.
Remove the filter cartridge form its housing by rotating
5.
counter clock-wise about a quarter turn (Fig. 19). This will
free the filter. Pull downward and remove it.
Fill sanitizing cartridge with Neutral Detergent. Insert the
6.
sanitizing cartridge on the filter head by rotating clock-wise
a quarter turn.
Open valve on the base of the unit
7.
(Fig. 12).
Dry any water from the base, that could have leaked during
8.
this operation.
Position under the water dispense nozzle a container or
9.
large cup.
Turn main switch. Wait approx.
10.
5 seconds and press "light" button until sanitizing mode is
entered. This will be shown in the display as a moving red
led through all the buttons. During this operation, the inside
of the unit will be sanitized. After this initial cleaning cycle,
the unit will dispense automatically some cold and ambient
water.
Shut off unit from main on/off switch.
11.
Close valve on base of unit (Fig. 18).
12.
Position under the water dispense nozzle a container and
13.
dispense water to empty sanitize cartridge and tubes.
Install new filter cartridge as shown on filter cartridge
14.
instructions (Fig. 20). Turn main on/off switch on and push
appliance into cabinet.
Wait 4 minutes before turning unit on through the touch
15.
button.
Dispense 1 liter of cold, ambient and carbonated water to
16.
fully rinse any sanitizing residue.
1.1.0 5.2007
21/40
Fig. 18
Fig. 19
Fig. 20
Refreshment Center
Advertisement
Table of Contents
