KitchenAid 5KSM5 Instructions Manual page 17

TO ATTACH BOWL
• Be sure speed control is OFF.
• Hold the locking lever in the UNLOCK
position and tilt motor head back.
• Place bowl on bowl-clamping plate.
• Turn bowl gently in clockwise direction.
TO REMOVE BOWL
• Turn speed control OFF.
• Holding the locking lever in the
UNLOCK position and tilt motor head
back.
• Turn bowl in counterclockwise direction.
TO ATTACH FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
• Turn speed control to OFF and unplug.
• Hold the locking lever in the UNLOCK
position and raise motor head.
• Slip beater onto beater shaft and press
upward as far as possible.
• Turn beater to right, hooking beater over
pin on shaft.
TO REMOVE FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
• Turn speed control to OFF and unplug.
• Hold the locking lever in the UNLOCK
position and raise motor head.
• Press beater upward as far as possible
and turn left.
• Pull beater from beater shaft.
Lock
TO LOCK MOTOR HEAD IN RAISED
POSITION
• Push locking lever up into UNLOCK
position and hold.
• Tilt motor head back.
• Move locking lever into LOCK position.
TO LOCK MOTOR HEAD IN
OPERATING POSITION
• Push locking lever up into UNLOCK
position and hold.
• Lower motor head until it is completely
down into operating position.
• Move locking lever into LOCK position.
• Before mixing, test motor lock by
attempting to raise head.
NOTE: Motor head should always be kept
in LOCK position when using mixer.
TO OPERATE CONTROL SPEED
• Speed control lever should always be set
on lowest speed for starting, then
gradually moved to desired higher speed
to avoid splashing ingredients out of
bowl.
See "Speed Control Guide."
R-5
Unlock