Advertisement
Whole Home Smart Wi-Fi
Water Leak Sensor Starter Kit
Quick Installation Guide
What's in the Box
Master Plug-in Smart Wi-Fi
Battery-powered Remote
Water Leak Sensor
(DCH-S162)
RJ11 Sensing Cable
Quick Installation Guide
Cable Clips
DCH-S163 pre-installed
DCH-S1621KT
Simple Setup
Pro Series
Please set up your device before mounting it.
1
2
3
Water Sensing Pod
(DCH-S163)
with 2 AAA batteries
Get the mydlink app on the App
Store or on Google Play. Launch the
app, then Sign In or Create a New
Account.
mydlink
Power on the device and wait for
the Status LED to flash orange.
Note: Make sure that your mobile device's
Bluetooth is on.
Place your device next to your
mobile device. A prompt will appear
- tap Add Device, then follow the
app instructions.
Note: If not automatically prompted
within 30 seconds, tap
Add Device.
Setup Code
This is your device's Setup Code.
Please keep it as future reference
for your device.
Alerts
When water is detected from any of the
sensors connected to your whole home
water leak system, ONLY the Master
Plug-in Smart Wi-Fi Water Leak Sensor
(DCH-S162) will sound an audible
alarm and an alert will be sent to your
smartphone notifying you as to which unit
was triggered.
then tap
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for MYDLINK Pro Series
Summary of Contents for MYDLINK Pro Series
- Page 1 Please set up your device before mounting it. Whole Home Smart Wi-Fi Water Leak Sensor Starter Kit Get the mydlink app on the App Store or on Google Play. Launch the Quick Installation Guide app, then Sign In or Create a New Account.
- Page 2 Connect the supplied RJ-11 Connected to the network and enabled sensing cable to the RJ-11 mydlink • Your mydlink device is in range of your port on the bottom of the Wi-Fi network DCH-S162. Booting up Note: If you need to further...
Need help?
Do you have a question about the Pro Series and is the answer not in the manual?
Questions and answers