Battery Connector (Also See Battery Connector Handling, Which Follows); Battery Connector Handling - Nokia RH-10 Series Disassembly/Assembly

RH-10
Disassembly / Assembly

Battery Connector (also see Battery Connector Handling, which follows)

(Disassemble) Insert the tip of a very thin, flat-tip screwdriver (or similar instrument)
between the battery connector and the B-cover wall (at approximately the center of the
battery connector). Gently rock the handle of the screwdriver (see photo below) down-
ward to disengage the two locking clips and to lift the battery connector upward.
(Assemble) Carefully place the connector in the B-cover. Then use a small screwdriver or
tweezer tip to push the center of the connector in order to fully seat. You should hear/
feel the locking mechanism engage.

Battery Connector Handling

The springs that make contact with the PWB can be easily bent while exposed or while
outside of an assembled phone. Take care NOT to touch these contacts at any time if the
connector is to be reused. Tweezers should be used to remove new connectors from tray.
Page 10
Nokia Corporation
CCS Technical Documentation
Confidential Issue 1 09/2002