PSBS5012D 1.3. Description of elements and connection links of the power-supply unit. Table 1. Elements of the power supply pcb (refer to chart 2). Element no. Description fuse in the battery circuit START pushbutton (power activation without AC supply) ;...
Page 5
PSBS5012D Table 2. Elements of the power supply (refer to chart 3). Element no. Description Separation transformer Power-supply unit board (tab. 1, fig. 2) TAMPER x2; microswitches (contacts) contact of antisabotage protection (NC) witch in the Power supply circuit (230V/AC)
PSBS5012D Operation safety (tab.5). Protection class PN-EN 60950-1:2007 I (first) Protection grade PN-EN 60529: 2002 (U) IP20 Electrical strength of insulation: - between input (network) circuit and output circuits of power-supply (I/P- O/P) 3000 V/AC min. - between input circuit and PE protection circuit (I/P-FG) 1500 V/AC min.
PSBS5012D 5. If necessary, connect the conductors from the equipment to the technical outputs: - FAC; status indication AC (alarm panel, controller, signaling unit, LED diode, etc.) - FPS; technical output of operation status of the power supply - TAMPER signalization of power-supply unit opening 6.
PSBS5012D 4. Service and operation. 4.1 Overloads or short circuits to the PSU. The AUX output of the PSU is equipped with the PTC polymer fuse assisted protection. If the load of the PSU exceeds I (load 110% ÷ 150% @25ºC of the PSU power), the output voltage is automatically disconnected and this is indicated by the green diode going off.
Page 10
GENERAL WARRANTY CONDITIONS 1. Pulsar K. Bogusz Sp.j. (the manufacturer) grants a five-years warranty for the equipment, counted from the device’s production date. 2. The warranty includes free-of-charge repair or replacement with an appropriate equivalent (the selection is at the manufacturer’s discretion) if the malfunction is due to the manufacturer, includes manufacturing or material defects,...
Need help?
Do you have a question about the PSBS 5012D and is the answer not in the manual?
Questions and answers