Advertisement
Quick Links
GARDEN STRUCTURES
HARDWARE LIST
A
B
C
D
PARTS LIST
1
Header Assembly
Side Panel
3
4
3
TOOLS REQUIRED
Power screwdriver or drill
Tape measure
Handy to have:
Stool or short ladder
Bit holder may be needed if using a drill with a
quick-change chuck
Product ID 820.1486 / Instruction ID 445.35.67
ASSEMBLY INSTRUCTIONS
GABLE ARBOR
REVIEW ALL STEPS BEFORE STARTING ASSEMBLY
Quantity
1¼" Screw
(28)
2½" Screw
(4)
Spacer block
Anchor stake kit
2
Brace
Cap
4
3
1
2
LWO Corp. / PO Box 17125 / Portland, OR / Cust. Serv. 800-459-8718
PRELIMINARIES
Selecting a Work Area
Select an area close to where the arbor will be installed.
The assembly area should be relatively flat and open, at
least 9'x7'. A lawn, driveway or wide path will be
satisfactory. It is a good idea to lay out the arbor box on
your work surface to protect the arbor from nicks and
scratches. Two people are handy for the assembly process.
Always use caution when assembling or moving the arbor.
Optional Painting or Staining
If you wish to stain or paint your arbor, we recommend
applying to individual components before assembly to
ensure fullest coverage. Use a high quality exterior stain or
paint. Be careful not to cover up guide marks on arches.
ASSEMBLED PRODUCT
GA
Updated 12/8/15
Advertisement
Related Manuals for Arboria GABLE ARBOR 820.1486
Summary of Contents for Arboria GABLE ARBOR 820.1486
- Page 1 GARDEN STRUCTURES ASSEMBLY INSTRUCTIONS GABLE ARBOR REVIEW ALL STEPS BEFORE STARTING ASSEMBLY HARDWARE LIST PRELIMINARIES Selecting a Work Area Quantity Select an area close to where the arbor will be installed. The assembly area should be relatively flat and open, at 1¼”...
- Page 2 GARDEN STRUCTURES ASSEMBLY INSTRUCTIONS GABLE ARBOR STEP 1 Align bottom of each brace with pencil marks on side panel posts. Fasten in place as shown with a 2½” screw. Pencil mark Repeat Step 1, attaching braces to the second side panel. STEP 2 Align top of side panel post precisely with pencil mark on inside of header.
- Page 3 GARDEN STRUCTURES ASSEMBLY INSTRUCTIONS GABLE ARBOR STEP 3 Repeat Step 2 to attach second header to the side panels. Carefully raise the arbor upright. Visually adjust the side panels as needed until arbor is plumb. Now drive the second screw on each post into the headers.
- Page 4 Be sure to You can trust the Arboria name for allow sufficient time for your product to dry. environmentally conscious, exceptional outdoor products.
Need help?
Do you have a question about the GABLE ARBOR 820.1486 and is the answer not in the manual?
Questions and answers