Advertisement
5. DRY VACUUM CLEANING
WARNING! Ensure you read, understand and apply
Section 1 'Safety Instructions'.
Reminder: DO NOT vacuum hazardous substances. Use
of an incorrect filter will invalidate your warranty.
5.1.
Whilst you are preparing the machine for use ensure that it is
unplugged from the power supply.
5.2.
Remove the power head. Stretch the opening of the
reusable cloth filter over the filter cage and push it down.
5.3
Ensure that the filter completely covers the filter cage
with the elastic portion stretched over the smooth ring of
plastic at the base of the filter cage.
5.4.
Reposition the power head onto the container, and secure
in place by rotating the two locking knobs.
5.5.
Insert the flexible hose into the front inlet port below the
on/off switch. Push the required attachment onto the free end
of the hose.
5.6.
Plug in the power supply.
5.7.
Switch the motor on (position 'I').
5.8.
When you have completed vacuuming, press the switch to
'Off' (position 'O'), and unplug from power supply.
Regularly check the condition of the filter.
6. WET VACUUM CLEANING
WARNING! Ensure you read, understand and apply Section 1
'Safety Instructions'. Reminder: Remove plug from power
supply before opening unit. DO NOT vacuum solvents,
explosives, inflammable and/or hazardous liquids such as
petrol, oil, spirits, paint, thinners, acids etc.
6.1.
Whilst preparing the unit for use ensure that the machine is
unplugged from the power supply. Make sure the tank is
clean and free from dust and dirt.
6.2.
Remove the reusable cloth filter and fit the foam filter over
the filter cage, replace the top section onto the container.
6.3.
To the same flexible hose as used in dry cleaning fit the
desired nozzle.
6.4.
Ensure the switch is 'Off' (position '0') before plugging into
the power supply.
6.5.
Press the switch to 'On' (position 'I').
6.6.
After use, empty the tank and dry.
To vacuum large quantities of liquid, from a sink or tank etc., do not
immerse the nozzle completely in the liquid, leave a gap at the top of
the nozzle opening to allow an air inflow. The machine is fitted with a
float valve which stops the suction when the tank has reached its
maximum capacity. The user will notice an increase in motor speed.
When this happens, turn off the machine, disconnect from power
supply, remove the head from the container and empty the liquid into
a suitable receptacle or drain. To continue vacuuming, refit the head
and proceed. After wet vacuuming, turn the machine off and remove
plug from power supply. Empty the container and clean/dry the inside
and outside before storage.
Remember! After wet vacuuming the foam filter must be removed
and a dry cloth filter must be fitted before dry vacuuming again.
7. BLOWING
7.1
Push one end of the flexible hose into the blowing outlet port
in the back of the power head.
7.2
Ensure the power switch is turned off and plug into the
power supply.
7.3
Switch on the power (position 'I').
7.4
The unit will now blow through the hose and can be used to
clear obstructions within the pipe.
WARNING! If after a few seconds the hose is still blocked turn
of the unit and clear the hose manually.
© Jack Sealey Limited
Original Language Version
PC100
Issue: 3(L) - 11/08/16
Advertisement
