Checking The Accessories; Installation And Connection - Pioneer CM Series Installation And Instruction Manual

Checking the Accessories

• U-bracket, 1 × 2 sets
*Attached on the main unit during shipment.
• Knob screw for U-bracket, 2 × 2 sets
*Attached on the main unit during shipment.
• 4-pin Euroblock connector, 1 × 2 sets
*Attached to the speaker's terminal
• Connecter cover, 1 × 2 sets
• M4×12 truss head tapping screw, 4 × 2 sets
*Used for attaching the connector cover.
• Fall prevention
wire, 1 × 2 sets
• Hook for fall prevention wire, 1 × 2 sets
• Bracket for fall prevention wire, 1 × 2 sets
• M6×14 Pan head screw with captive washer, 1 × 2 sets
*Fall prevention wire installation screw
• Bracket cap, 2 × 2 sets
*Used for attaching without the use of the standard
U-bracket.
• M6×12 Countersunk bolt, 2 × 2 sets
*Used for attaching the wire cap.
• Precautions for use, 1 unit
4

Installation and Connection

WARNING
• Make sure that the wall or ceiling where you are installing the
speaker is strong enough to support it.
• Use screws that are appropriate for supporting the weight of the
loudspeaker.
CAUTION
• Supported wire diameter: 12 AWG to 22 AWG
• The walls and ceiling will resonate with loudspeaker output, causing
impaired sound quality, so reinforce the wall or ceiling sufficiently.
• When you install the loudspeaker vertically, install it with the
terminals facing up.
Attaching the U-Bracket to a Wall or
Ceiling
1 Turn the U-bracket knob screw 1 counterclockwise to
remove it and then remove the U-bracket 2 from the
loudspeaker.
2
2 Use the round holes 1 at two places on both ends of the
back and attach the U-bracket to the wall or ceiling.
By passing the speaker cable through the hole 2 in the center of
the U-bracket, you can route the speaker cable in such a way that it
does not stand out.
1
1
2
1