Replacing The Lamp; Troubleshooting - Zanussi ZOB65922XU User Manual

Table of Contents

Advertisement

Available languages

Available languages

8. Clean the glass panels with water and soap.
Dry the glass panels carefully. Do not clean the
glass panels in the dishwasher.
When the cleaning is completed, install the glass
panel and the oven door.
The screen-printing zone must face the inner side
of the door. Make sure that after the installation the
surface of the glass panel frame on the screen-
printing zones is not rough when you touch it.
When installed correctly the door trim clicks.
Make sure that you install the internal glass panel in
the seats correctly.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
28

REPLACING THE LAMP

1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The back lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C heat-
resistant lamp.
4. Install the glass cover.
A
Possible cause
The oven is deactivated.
The clock is not set.
The necessary settings are not
set.
The fuse is blown.
The lamp is defective.
WARNING! Risk of electric shock.
The lamp can be hot.
CAUTION! Always hold the halogen
lamp with a cloth to prevent grease
residue from burning on the lamp.
Remedy
Activate the oven.
Set the clock.
Make sure that the settings are
correct.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Replace the lamp.

Advertisement

Table of Contents
loading

Table of Contents