Canon DP-V3120 Service Manual page 56

1. Before Disassembly
1.1 Required Tools and Supplies
Phillips screwdriver with torque control (bit #1), Length; 100mm
Phillips screwdriver with torque control (bit #2), Length; 100mm Philli d i ith t
Hex key (5 mm; Hexagon width across flats)
Hex Nut Screwdriver (5.5 mm; Hexagon width across flats)
Tweezers Tweezers
Pole made of Styrofoam (height 8 cm)
TAPE, ROLL(NO.156A)10MM X 30M
BOND, DIABOND NO.1663G BLACK
GPI CHECKER GPI CHECKER
CABLE, DC POWER SUPPLY
1.2 Precautions against Electric Shock and Hot Components
•Electric shock caution mark
This mark appears on parts of the circuit board to indicate possible electric shock hazards. Before working on such parts, be sure to remove the
power cord, and do not touch them.
•Hot caution mark
Thi This mark appears on parts of the circuit board to indicate that they become hot. When the display is turned on, or even after a short time after k t
the power is turned off, touching such parts may cause burns. Before working on such parts, be sure to remove the power cord, and do not touch
them.
Name
t l (bit #2) L th 100
f th i it b d t i di t th t th
Purpose
Disassembly and assembly
Di Disassembly and assembly bl d bl
Disassembly and assembly
Disassembly and assembly
Disassembly and assembly Disassembly and assembly
To protect the monitor from damage
For [COVER, FRONT BEZEL]
For [KNOB, JOG] Assembly
For GPI/TALLY lamp check For GPI/TALLY lamp check
For Connecting DC POWER SUPPLY
b h t Wh th di l
Page 3
Notes
For M2 screws
For M3 screws and M4 screws F M3 d M4
For [HANDLE] Detachment
For [TCON PCB, DRIVER PCB] Detachment
Part Number:CY9-5710-000
Part Number:CY9-8129-000
Part Number:CY9 5712 000 Part Number:CY9-5712-000
Part Number:CY9-5713-000
i t d ft h t ti ft