KitchenAid 4-C Recipes & Instructions page 7

A.
9
It
/
4
SPEED CONTROL
1 2 4
6 8
10 -
UNDERSTANDING YOUR FOOD PREPARER
MODEL K5-A
Your new K5-A Food Preparer comes equipped with a 5-quart stainless steel Bowl, a Flat
Beater, a Wire Whip and a Dough Hook.
A. Flat Beater. . . is used for normal and heavy mixtures
such as cakes, creamed icings, candies, pie pastry,
cookies, biscuits, quick breads, meat loaf and mashed
potatoes.
B. Wire Whip. . . is used for mixtures which need to in-
corporate air such as eggs, egg whites, whipped
cream, boiled frostings, sponge or angel cakes, may-
onnaise, milk drinks, waffle batter and some candies.
C. Dough Hook. . . is used for mixing and kneading yeast
breads.
1. Speed Control Lever— 5. Knob for securing attach-
acts as both "on" and
"off" switch and regu-
lates speed of Beaters.
2. Motor Head—stationary
3. Spring latch—secures
Bowl.
4. Attachment hub (See
page 33)
ments
6. Beater Shaft—attach Flat
Beater, Whip or Dough
Hook here.
7. Stainless Steel Bowl
8. Locating Pins
9. Bowl Lift Handle
10. Bowl Supports
11. Bowl Pin
TO RAISE AND LOWER BOWL
To Raise Bowl . . . Rotate Handle (9) back and up until it
snaps into the locked vertical position. Bowl must always
be in this raised, locked position when mixing. To Lower
Bowl. . . rotate Handle back and down.
TO ATTACH BOWL...
Be sure Speed Control (1) is OFF. Bowl Lift Handle
should be in the down position. Fit Bowl Supports (10)
over Locating Pins (8) and press down on back of Bowl
until Bowl Pin (11) snaps into Spring Latch (3). Raise
Bowl before beginning mixing process.
TO REMOVE BOWL...
Bowl Lift Handle should be in the down position. Lift
back of Bowl to remove Bowl Pin from Spring Latch. Lift
Bowl from Locating Pins.
TO ATTACH AND REMOVE BEATER, WHIP OR
DOUGH HOOK...
Turn Speed Control to OFF and lower Bowl. Slip Beater
on Beater Shaft (6) and press upward as far as possible.
Turn Beater to right, hooking Beater over the Pin (12) in
Shaft.
To remove. . . press Beater upward as far as possible and
turn to the left. Pull Beater from Beater Shaft.
TO CONTROL SPEED
Speed Control Lever turns motor "on" and "off" and
regulates the speed of the Beater, Whip or Dough Hook.
Speed Control should always be set on lowest speed for
starting, then gradually moved to desired higher speed
setting to avoid splashing ingredients out of Bowl. See
page 5 for Speed Control Guide.
4