Troubleshooting - National Geographic WIFI Weather Center 7in1 Instruction Manual

Time signal
DAYLIGHT SAVING TIME (DST)
Dimensions
Weight (incl. batteries)
Multisensor
Batteries
Maximum number of sensors
Transmission frequency
RF Transmission range
Maximum radio-frequency power
Temperature measuring range
Barometer measuring range
Humidity measuring range
Humidity resolution
Precipitation measuring range
Wind speed measuring range
Dimensions
Weight (incl. batteries)
Wi-Fi specifications
Wi-Fi standard
Wi-fi operating frequency :
Supported devices
Supported internet browsers

50 Troubleshooting

Problem
The 7-in-1 wireless sensor
connection is interrupted or
has no connection
The wireless indoor sensor is
temporarily interrupted or dis-
connected
No WIFI connection
Data is not sent to wunder-
ground.com or weather-
cloud.net.
60 / 64
Through Internet time server to synchronize the
UTC
AUTO / OFF
118 x 192.5 x 21 mm (W x H x D)
260 g
3x AA, 1.5V
1x wireless multisensor
868Mhz
150 m
< 25mW
from -40°C to 60°C (from -40°F to 140°F)
540 to 1100hPa
From 1 to 99%
1% HR
From 0 to 19999 mm (from 0 to 787.3 inch)
From 0 to 112 mph, 50 m/s, 180km/h, 97 knots
343.5 x 393.5 x 136 mm (W x H x D)
673 g
802.11 b/g/n
2.4 GHz
Smart device with built-in WIFI AP mode (Access
Point) function, PC or notebook, Android or iOS
smartphone/tablet
Internet browser that support HTML 5
Solution
1. 1. Make sure that the sensor is within the transmission range.
2. 3. If it still does not work, reset the sensor and resynchronize it with
the base station.
1. 1. Make sure that the sensor is within the transmission range.
2. 2. Make sure that the displayed channel matches the channel selec-
tion on the sensor
3. 3. If it still does not work, reset the sensor and resynchronize it with
the base station.
1. Check whether the WIFI symbol is shown on the display. It should al-
ways be displayed.
2. 2. Make sure that you connect to your WIFI router using the 2.4G
band and not the 5G band.
1. 1. Make sure that your Station ID and Station Key are correct.
2. Make sure that the date and time on the tablet are correct. If they are
incorrect, you may be reporting old data rather than real-time data.
3. Make sure that your time zone is set correctly. If it is set incorrectly,
you may report old data rather than real-time data.