Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Genesis GBP-ST2000
Summary of Contents for Genesis GBP-ST2000
- Page 1 EXTERNAL ROLLER SHUTTER INSTALLATION INSTRUCTION GBP-ST2000 Without Mosquito Screen...
-
Page 2: Mounting Types
Mounting types Type "A" Type "B" Type "C"... - Page 3 Prior to mounting, the blind should be unpacked and check that all the elements necessary for its installation are present. MOUNTING TYPE "A" min. 70mm max. 90mm 500mm 500mm Dimensioning: H - height of recess S - width of the recess 1.Tools needed for installing the blind.
- Page 4 9. After making the opening for the tape, insert a PVC pipe with a diameter of 20 mm into the hole and cut it flush with the external wall (Genesis Building Products does not provide this element in the set). From the inside, the tube must be shorter by 2 cm from the wall plane due to the construction of the ribbon grommet.
- Page 5 Pass the strap, cable or power cord through the opening into 14. Carefully slide the box onto the guides, carefully inserting the the building. shank pins into the upper part of the guides, check the correctness of the slide mounts. Pass the cable or strap through the grommet, then fasten the Make sure that the blind is properly fixed (horizontal and vertical).
- Page 6 MOUNTING TYPE "B" & "C" MOUNTING TYPE "B" MOUNTING TYPE "C" o 10 o 10 o 10 Drill the holes in the guides. Using a 6mm drill bit, make a hole through the two guide chambers and drill a 10mm drill bit to increase the opening in the first chamber only from the outer side of the guide (TYPE C - increase the hole in the middle wall of the guide).
- Page 7 MOUNTING TYPE "C" 5. With MOUNTING TYPE "C" - drill holes in the marked places 6. Carefully insert the end cap pins into the upper part of the on the wall guides, check the correctness of the profile blade slider 25 mm Carefully slide the box with the standard or angle guides into the With a type of cavity mounting as a manual drive, GBP recommends...
- Page 8 Make sure that the blind is properly fixed (horizontally and vertically). Tighten the screws in the guides and then insert the blanking plugs. Check the correct functioning of the blind. Check the correct operation of automatic bolts, bolts or locks, if necessary, make adjustments. Mount the retractor vertically in relation to the cable or tape Lower the shutter armor, then the cable should be cut to a length of 25 cm below the mounting location of the retractor.
- Page 9 ROLLER SHUTTER OPERATING INSTRUCTION 1. Raising the blind Grab the strap and pull it down. During this time, the loose part of the tape will be rolled up to the retractor and the roller shutter's armor will rise to a certain height. Repeat the procedure several times until the armor stops by the limiters mounted in the bottom bar and the blind is completely open.
- Page 10 7. Noise emission through a roller blind is not considered a significant hazard and is a matter of comfort. Level the emission of sound pressure is less than or equal to 70 dB (A). Genesis Building Products LLC 348 County Road 3521 Bullard, TX.
Need help?
Do you have a question about the GBP-ST2000 and is the answer not in the manual?
Questions and answers