Installation - Siemens VersiCharge Ultra 175 Installation Manual

VersiCharge Ultra 175™ | Installation Manual

Installation

1. Remove lower front panel
Use the 5mm pin hex tool to unscrew the 4 security screws (2
per side) from the front panel, then remove them. Pull the front
panel forward to remove and safely store all parts.
2. Remove rear-lower panel
Follow this step to increase visibility and access to the mounting
holes. If visibility and access is sufficient, go to step 3. Use the
4mm Allen wrench to unscrew the 4 screws that attach the rear
panel to the enclosure and slide out to remove.
12
3. Remove shipping bolts
Unscrew the 4 bolts from the shipping base (optional fiber
optic interface module not shown).
4. Secure to foundation
Lift the VersiCharge Ultra 175 unit and place over the prepared
foundation. Feed the conduit and wiring through the power
in-hole, and secure to the foundation fixing points. (Fasteners
not supplied)
Note: Use the plastic inserts in the holes of the baseplate.