Switch The Alarm On/Off - Silvercrest SCUR 3 A1 Operating Instructions And Safety Instructions

♦ Press the ALARM button
alarm tone
♦ If you have selected radio or CD playback, you must use the −VOL+/
І◄◄ TUNE ►►І dial
Press the ALARM button
♦
Switch the alarm on/off
Switching the alarm on
♦ While the device is in standby mode, press the ALARM button
desired alarm function is shown on the display
–
–
–
–
Pausing the alarm
♦ You can pause the alarm (alarm, radio or CD) for 9 minutes by pressing
the SNOOZE/DIMMER button
"SNOOZE" appears on the display
NOTE
► If the alarm is not switched off, it stops automatically after 60 minutes.
► If CD playback is activated as the alarm mode and there is no CD in the
CD compartment
Switching off the alarm
♦ Press the
alarm. The set alarm time remains programmed.
NOTE
► The alarm is finished for 24 hours and will reactivate at the set alarm time.
Switching the alarm off completely
♦ To switch off the alarm completely, press the ALARM button
standby mode until the symbol
shown on the display
SCUR 3 A1
, the setting process is now complete.
to set the volume (L15–L25).
AL1
Alarm 1 is activated
AL2
Alarm 2 is activated
AL1
AL2
Alarm 1 and 2 are activated
If no symbol is displayed, both Alarm 1 and 2 are deactivated.
, the alarm tone will play instead.
/SOURCE button
.
to save the selection. If you have selected the
to save the setting.
:
. While the SNOOZE function is active,
.
or the ALARM button
AL1
AL2
or or "AL 1" or "AL 2" is no longer
until the
to switch off the
while in
GB │ IE
47 ■
│