Battery pack
Remove the solid-state drive
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 32
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Step 2.
Remove one screw and then remove the solid-state drive bracket.
Figure 18. Remove the solid-state drive bracket
Screw specifications
M2 x L2.8
Step 3.
Remove the solid-state drive by pulling it away from the slot.
Figure 19. Remove the solid-state drive
Number of screws
1
.
Chapter 4
Removing a FRU or CRU
41