Change Items Setting; Operation Setting; Batch Setting - Fujitsu Airstage UTY-DCGYZ1 Operating Manual

2-1-1. Change Items Setting


No. Item
"Management Status" display

"Operation Status" selection

"Group Icon" size
3
2-2. Operation Setting
Perform the operation setting for the group or R.C.G. registered to this controller.
(1) Batch setting: Performs the same setting to all R.C.G. registered to this controller.
(2) Individual setting: Performs the individual setting for the tapped group or R.C.G..
When the password is set at start-up, enter the password. (Refer to 3-2-5.)
2-2-1. Batch Setting


3
En-16
3
When checkbox is checked, the icons of "R.C. prohibition", "Temp. upper
and lower limit", and "Schedule" are displayed on the group. The display
switches to normal icon display automatically 12 seconds after the scroll
button, etc. is tapped.
Switches between enabled and disabled state of the display by checkbox.
Up to 2 items of "Mode", "Room Temp.", "Set Temp." can be enabled. All
items cannot be disabled. When one of "Room Temp." or "Set Temp." is
enabled or both of "Room Temp." and "Set Temp." are enabled, "Temp.
Unit" can be enabled.
Sets the group icon size to be displayed. [Initial value: Auto]
"Auto": When the number of registered group is 6 or less, icons are large.
When it is 7 or more, icons are small.
"Large": Icons are large. (maximum number of display group: 6)
"Small": Icons are small. (maximum number of display group: 12)
(1) Tap the following item.
No. Item
"On"

"Off"

"Detail"
3
Description
Description
Sets all R.C.G. to ON collectively.
Sets all R.C.G. to OFF collectively.
Sets the details of batch operation. The
screen is the same as the individual
setting. → Refer to 2-2-2.