Maintenance And Cleaning; Water Inlet Filters; Pump Filter - Whirlpool AWG 233 Instructions For Use Manual

MAINTENANCE AND CLEANING

•
Unplug your machine.
•
Close the water tap.

WATER INLET FILTERS

On the tap part of your machine's water inlet hose and at the extremities of
the water inlet valves, there are filters to prevent entrance of dirt and foreign
bodies into the water to the machine. If the machine is unable to receive
sufficient water although your water tap is opened, these filters should be
cleaned.
•
Remove the water inlet hose.
•
Remove the filters found on the water inlet valves by using tweezers
or pliers and wash thoroughly with a brush.
•
Clean the filters of the water inlet hoses located on the tap side by
removing manually, together with the seal.
•
After cleaning the filters, they can be refitted by reversing the removal procedure.

PUMP FILTER

The pump filter system prolongs the life of your pump, which is used to drain
the dirty water. It prevents lint from entering the pump. Cleaning your pump
filter every 2-3 months is recommended. To clean your pump filter:
•
Remove the kickplate by pushing upwards with your hand from the
lower claws and pulling towards yourself.
•
Before opening the filter cover, place a cup in front of the filter cover
to prevent flow of the remaining water in the machine.
•
Loosen the filter cover by turning counter clockwise and drain the
water.
•
Remove the foreign bodies from the filter.
•
Check for the rotation of the pump manually.
•
After you have cleaned the pump, refit the filter cover by rotating
clockwise.
•
Refit the kickplate by holding from the claws and pushing it.
•
Do not forget that if the filter cover is not properly refitted, it will leak
water.
28