Spare Parts; Data Label - Mandik FDMB Manual

Before entering the dampers with actuating mechanism into operation after their assembly and
by sequential checks, checks according 16.2. and following checks must be carried out.
Check of blade displacement into the breakdown position "CLOSED" can be done after cutting
off the actuating mechanism supply (e.g. by pressing the RESET button at the thermoelectrical
starting mechanism BAE 72B-S or cutting off the supply from ELECTRICAL FIRE SIGNALISA-
TION). Check of blade displacement back into the "OPEN" position can be done after restoration
of power supply (e.g. By releasing the RESET button or restoration of supply from ELECTRICAL
FIRE SIGNALISATION).
Spare parts are supplied only on basis of an order.
Control for square damper and round damper is identical.
If fuse Tf1 is initiated ( duct outside temperature ) than is necessary to change thermoelectrical
starting mechanism BAE72B-S. Whereas is initiation temperature higher than actuator
mechanism operating temperature +50°C, recommended actuating mechanism manufacturer
make complete revision or change actuating mechanism and thermoelectrical starting mechanism.
If fuses Tf2/Tf3 are initiated ( duct inside temperature ) than is possible change only part ZBAE72,
or ZBAE95 (according initiating temperature).
Data label is placed on the damper body.
FIRE DAMPER FDMB-S
CLASSIFICATION:
SIZE:
SERIAL NUMBER:
TPM075/09 Certification:
MANDÍK, a.s.
267 24 Hostomice
EI 90 (ve ho i o) S
DESIGN:
WEIGHT (kg):
1391-CPD-0113/2012
106
Dobříšská 550
Czech Republic
12 EN 15650:2010
1391