Download Print this page

Water Supply Indicator Light; Adjustment Of Sensor Detection Sensitivity - Sharp KC-860U User Manual

Hide thumbs

Advertisement

Refer to the diagram to select the desired brightness on the front panel.

WATER SUPPLY INDICATOR LIGHT

When the Water Tank is empty, the Water Supply Indicator Light will flash to indicate that the Water Tank should
be refilled. Please note the light will not flash even when the Water Tank is empty during the Clean Air Mode and
the Quick Clean Mode.
Sound indicator setting for water supply.
In addition to the Indicator Light, the unit can be set to signal with an audible beep when the Water Tank is empty.
With the unit OFF, press the Lights Control button for 3 seconds to turn the audible signal ON.
Cancellation
To cancel the audible signal, with the unit OFF, press the Lights Control button again more than 3 seconds.

ADJUSTMENT OF SENSOR DETECTION SENSITIVITY

Set to 'low" if the DUST MONITOR is constantly red to reduce sensitivity, and set to 'high' if the DUST MONITOR
is constantly green to increase sensitivity.
1. With the unit OFF, press the Fan Speed Button for 3 seconds.
The Fan Speed Indicator Lights will display the currently set sensor sensitivity level. The factory setting is
Standard, indicated by the MED light.
2. Press the Fan Speed Button to set the desired sensor sensitivity.
Refer to the diagram on the right to select the desired sensor sensitivity level.
3. Press the Power OFF Button.
Note that if the Power OFF Button is not pushed within 8 seconds of adjusting sensor sensitivity, the setting will
be saved automatically. The sensor sensitivity setting will be saved even if the unit is unplugged.

Advertisement

loading

  Related Manuals for Sharp KC-860U