Sleepnet MOJO 55045 Fitting Tips

Sleepnet MOJO 55045 Fitting Tips

Full face mask

Advertisement

1. The mask shell can be shaped and re-shaped to follow the contours of the face. If the
mask has been shaped previously, return the shell to its original shape by holding the
mask with your thumbs inside the shell, parallel, and bend the wire outward until the
gel resembles a triangular pear.
2. Turn the mask around (elbow towards you) and rotate the tensioning wheel clockwise
as far as it will easily turn; do not screw wheel off its support screw. Bend the
forehead pad flat.
3. Assemble the mask to the headgear according to the product instructions. Put mask
assembly on head; center mask on face, with top of mask gel cushion on the nose
bridge and between the eyes and forehead pad on brow. The mask should rest with
the bottom of gel cushion just below the lips and above the chin. Adjust the headgear
straps for a comfortable fit.
4. Connect the mask elbow to the airway pressure device tubing and turn the unit on.
Begin at a low pressure setting to check mask fit and seal.
5. If you feel air leaks at the bridge of your nose, turn the tensioning wheel counter-
clockwise until leaks are reduced. This will divert the force of the upper straps, down
the top of the mask shell, and in towards the bridge. (Note: the tensioning wheel can
come off the screw if it is turned too far, but can be re-attached.)
6. If you feel air leaks around the cheeks and mouth, gently press on the wire
embedded inside the shell to seal the leaks. The wire is very durable and can be
maneuvered repeatedly.
7. If necessary, pull the mask away from the face and reset over nose and mouth; move
mask higher or lower; readjust headgear. The device tubing can be secured to the
headgear frame with the headgear loop strap, draped to either side, or downward.
Please contact us if you have any questions on your Mojo Mask and headgear;
603-758-6600 www.sleepnetcares.com
91007 Rev. D
The MOJO
SleepNet Corporation • 5 Merrill Industrial Drive, Hampton, NH 03842 USA
1.800.742.3646 US & Canada • Tel. +603.758-.6600 • Fax. +603.758.6699
"SLEEPNET" and "MOJO" are registered trademarks of SleepNet Corporation.
Full Face Mask
• Comfort is our priority

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MOJO 55045 and is the answer not in the manual?

Questions and answers

Summary of Contents for Sleepnet MOJO 55045

  • Page 1 Please contact us if you have any questions on your Mojo Mask and headgear; 603-758-6600 www.sleepnetcares.com SleepNet Corporation • 5 Merrill Industrial Drive, Hampton, NH 03842 USA 1.800.742.3646 US & Canada • Tel. +603.758-.6600 • Fax. +603.758.6699 "SLEEPNET" and "MOJO" are registered trademarks of SleepNet Corporation.
  • Page 2 The MOJO Full Face Mask ™ If the tensioning wheel has unscrewed from its post, it can be re- screwed into place. Hold the mask shell with your thumb inside the shell, pressed against the base of the post; wrap your fingers around the dual beam element, as illustrated, and replace the tensioning screw inside its slot, perpendicular to the post.

This manual is also suitable for:

Mojo 50837Mojo 50836Mojo 50835008147470201280081474702013500814747020142

Table of Contents