Print-Quality Problems - Xerox B215 User Manual

Print-Quality Problems

Your printer is designed to produce consistently high-quality prints. If you observe print-quality
problems, use the information in this section to troubleshoot the problem. For more information, go to
www.xerox.com/office/B215support
CAUTION:
The Xerox
unsupported paper or specialty media.
Note: To ensure consistent print quality, the toner cartridge and drum cartridge are designed to
cease functioning at a predetermined point.
Controlling Print Quality
Various factors can affect the quality of the output of your printer. For consistent and optimum print
quality, use paper designed for your printer, and set the paper type correctly. To maintain optimum
print quality, follow the guidelines in this section.
Temperature and humidity affect the quality of the printed output. The guaranteed range for optimal
print quality is 0–50
o
1
Solving Print-Quality Problems
When the print quality is poor, select the closest symptom from the following table, then refer to the
corresponding solution. If the print quality does not improve after completing the appropriate action,
contact a service representative.
Note: To maintain print quality, when toner is low, a warning message appears on the control
panel. When the toner cartridge is empty, the printer stops printing, and a warning message
appears that prompts you to replace the toner cartridge. The printer stops printing until you install
a new toner cartridge.
Symptoms
Light or faded print
Warranty or Service Agreement does not cover damage caused by using
®
C (50–122 F) and 30–80% relative humidity.
o
Solutions
• If a vertical white streak or faded area appears on the page, the toner supply is
low. You may be able to temporarily extend the toner cartridge life. For details,
refer to Redistributing
new toner cartridge.
• The paper may not meet paper specifications; for example, the paper may be
too moist or rough. For details, refer to
• If the entire page is light, the print resolution setting is too low or the toner save
mode is on. Adjust the print resolution and turn the Toner Save mode off. See
the help screen of the print driver.
• A combination of faded or smeared defects may indicate that the toner
cartridge needs replacing. For details, refer to
Toner. If this does not improve the toner quality, install a
Supported
Replacing the Toner
Xerox B215 Multifunction Printer
®
Print-Quality Problems
Paper.
Cartridge.
User Guide
236