Operation; Maintenance; Optional Accessories - Makita DJR143 Instruction Manual

NOTE:
• If you remove the saw blade without rotating the
blade clamp sleeve fully, the sleeve may not be fixed.
In this case, rotate the blade clamp sleeve fully, then
make the sleeve fixed at the released position.
For Model DJR185
► Fig.9: 1. Hex wrench 2. Bolt 3. Loosen 4. Tighten
► Fig.10: 1. Recipro saw blade 2. Hex wrench 3. Hole
for recipro saw blade 4. Blade clamp
To install the saw blade, loosen the bolt by hex wrench.
When installing a recipro saw blade, press the bolt with the
hex wrench to open the slot during inserting the blade.
► Fig.11: 1. Saw blade 2. Blade clamp 3. Hole for
recipro saw blade 4. Hole for jig saw blade
► Fig.12
You can use both jig saw blades (B type) and recipro
saw blades according to your work. Insert the saw
blade straight into the blade clamp and tighten it by hex
wrench. Pull the saw blade lightly to make sure that the
saw blade does not fall off during operation.
To remove the saw blade, follow the installation proce-
dure in reverse.
Hex wrench storage
► Fig.13: 1. Hex wrench 2. Protrusion
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.

OPERATION

CAUTION:
• Always press the shoe firmly against the work-
piece during operation. If the shoe is held away
from the workpiece during operation, strong
vibration and/or twisting will be produced, caus-
ing the blade to snap dangerously.
• Always wear gloves to protect your hands from
hot flying chips when cutting metal.
• Be sure to always wear suitable eye protection
which conforms with current national standards.
• Always use a suitable coolant (cutting oil) when
cutting metal. Failure to do so will cause prema-
ture blade wear.
► Fig.14
Press the shoe firmly against the workpiece. Do not allow
the tool to bounce. Bring the saw blade into light contact
with the workpiece. First, make a pilot groove using a
slower speed. Then use a faster speed to continue cutting.
► Fig.15
► Fig.16
• You can use the switch lever or trigger according
to your work.
NOTE:
• If the tool is operated continuously until the
battery cartridge has discharged, allow the tool
to rest for 15 minutes before proceeding with a
fresh battery.

MAINTENANCE

CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before attempt-
ing to perform inspection or maintenance.
• Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always
using Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
• These accessories or attachments are recom-
mended for use with your Makita tool specified
in this manual. The use of any other accessories
or attachments might present a risk of injury to
persons. Only use accessory or attachment for
its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Recipro saw blades
• Jig saw blades (only for Model DJR185)
• Makita genuine battery and charger
NOTE:
• Some items in the list may be included in the
tool package as standard accessories. They
may differ from country to country.
9 ENGLISH