Bosch UniversalRake 900 Original Instructions Manual page 16

16 | English
60884-2-7 and are of type H05VV-F
or H05RN-F.
If you want to use an extension cable
when operating your product, only the
following cable dimensions should be
used:
– Nominal conductor area of
2
1.25 mm or 1.5 mm
– Maximum length 30 m for a Cord
Extension Set or maximum length
of 60 m for a Cable Reel with Re-
sidual Current Device (RCD).
Note: If an extension cable is used it
must be earthed and connected
through the plug to the earth cable of
your supply network in accordance
with prescribed safety regulations.
If in doubt contact a qualified electri-
cian or the nearest Bosch Service
Centre.
WARNING! Inadequate ex-
tension cables can be dan-
gerous. Extension cable,
plug and socket must be of water-
tight construction and intended for
outdoor use.
For products not sold in GB:
WARNING: For your safety, it is re-
quired that the plug attached to the
product is connected with the exten-
sion cord. The coupling of the exten-
sion cord must be protected against
splash water, be made of rubber or
coated with rubber. The extension
cord must be used with a cable strain
relief.
Products sold in GB only:
F 016 L94 116 | (23.10.2020)
Your product is fitted with an BS
1363/A approved electric plug with in-
ternal fuse (ASTA approved to BS
1362).
If the plug is not suitable for your
socket outlets, it should be cut off and
an appropriate plug fitted in its place
2
by an authorised customer service
agent. The replacement plug should
have the same fuse rating as the ori-
ginal plug.
The severed plug must be disposed of
to avoid a possible shock hazard and
should never be inserted into a mains
socket elsewhere.
Products that are only sold in AUS
and NZ: Use a residual current device
(RCD) with a nominal residual current
of 30 mA or less.
Maintenance
Always wear gardening gloves
u
when handling or working near the
sharp tines/blades.
Keep all nuts, bolts and screws tight
u
to ensure safe working with the
product.
Check the grass box frequently for
u
wear or deterioration.
Inspect the product and replace
u
worn or damaged parts for safety.
Ensure replacement parts fitted are
u
Bosch-approved.
Before storing, make sure that the
u
product is clean and free of residue.
If necessary, clean with a soft dry
brush.
Bosch Power Tools