Indication For Cd Player; Indication For Ipod Mode; Indication For Usb Memory - Alpine CDE-102 Owner's Manual

Indication for CD Player

• No CD is inserted.
- Insert a CD.
• Although a disc is inserted, "NO DISC" is displayed and the unit
does not start to play or eject the disc.
- Remove the disc by following these steps:
Press the button again for at least 2 seconds.
If the disc still does not eject, consult your Alpine dealer.
• Mechanism error.
1) Press the button and eject the CD.
If not ejecting, consult your Alpine dealer.
2) When the error indication remains after ejecting, press the
button again.
If the error indication still does not turn off after pressing the
button for a few times, consult your Alpine dealer.
• When "ERROR" is displayed:
If the disc cannot be ejected by pressing
(refer to page 6) and press
If the disc still cannot be ejected, consult your Alpine dealer.
• A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
• A sampling rate/bit rate not supported by the unit is used.
- Use a sampling rate/bit rate that is supported by the unit.

Indication for USB memory

• Abnormal current is run to the USB connector device (an error
message may be displayed if the USB device that is not
compatible with the unit is connected).
USB memory is a malfunction or it is shorted.
- Connect another USB memory.
UNIT ERROR
• A USB device that is not supported by the unit is connected.
- Connect a USB device that is supported by the unit.
NO DEVICE
• A USB memory is not connected.
- Make sure the USB memory device is correctly connected and
the cable is not excessively bent.
• No song (file) is stored in the USB memory.
- Connect the USB memory device after storing songs (files).
, press the RESET switch
again.
• A sampling rate/bit rate not supported by the unit is used.
- Use a sampling rate/bit rate that is supported by the unit.
• A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
NO SUPPORT
• Text information that is not recognizable by the unit has been input.
- Use a USB memory device with input text information that is
supported by the unit.

Indication for iPod Mode

• The iPhone/iPod is not connected.
- Make sure the iPhone/iPod is correctly connected (refer to
"Connections").
Make sure the cable is not bent excessively.
• There are no songs in the iPhone/iPod.
- Download songs to the iPhone/iPod and connect to this unit.
• Communication error.
- Turn the ignition key off, and then set to ON again.
- Reset the iPod.
- Check the display by reconnecting between the iPhone/iPod
and this unit, using the iPhone/iPod cable.
• Caused by the iPhone/iPod Software Version not being
compatible with this unit.
- Update the iPhone/iPod Software Version to be compatible with this unit.
• The iPhone/iPod is not verified.
- Reset the iPod.
- Try another iPhone/iPod, if available.
• Power surge error.
- Excessive voltage/current is supplied to the iPhone/iPod.
- Try another iPhone/iPod, if available.
Indication for all Modes
• Malfunction occurred as a result of the speaker cable shorting on
the car chassis.
- Route the cable correctly, and set POWER IC to POW ON (page 16).
If the above solution does not work, consult your nearest dealer.
23
-EN