Anderic RRST01.2 Operating Manual

Anderic

Thank you for purchasing the Anderic RRST01.2 universal remote control. This remote is

programmed to work with Roku

'Vol+/-'). This remote can be programmed to work any TV via the learning method. Please refer to

the "Learning Instructions" section for instructions, no codes needed. However, if you have a

Roku TV, you can program this remote work via the below table "Programming Codes for Roku

NOTE: This remote does not work for Roku Sticks

Downloadable (PDF) version of this manual is available at:

Installing batteries and the wrist strap

Please see the diagram below.

1. Remove the battery cover.

2. Insert the batteries, as shown in the diagram below, matching polarities.

3. Loop the wrist strap around the screw hole and hold in place while

replacing the battery cover.

RRST01.2 Advanced Universal

Operating Guide

Media Players and LG

TVs."

ANDERIC.COM/RRST01

/Vizio

TVs (for the keys: 'Power,' 'Mute,'

Table of Contents

Do you have a question about the RRST01.2 and is the answer not in the manual?

Page 1 ® Anderic RRST01.2 Advanced Universal Operating Guide Thank you for purchasing the Anderic RRST01.2 universal remote control. This remote is programmed to work with Roku ® Media Players and LG ® /Vizio ® TVs (for the keys: ‘Power,’ ‘Mute,’ ‘Vol+/-’). This remote can be programmed to work any TV via the learning method. Please refer to the “Learning Instructions”...
Page 2 Programming Codes for Roku TVs Use the codes below to program to Roku TVs (TVs manufactured by one of the brands below with built-in Roku software). Steps: 1. Take note of the two keys to press from the “Code” column corresponding with your TV brand from the “Brand”...
Page 3 1-2 inches apart (both remotes should be pointing at each other). 3. On the RRST01.2, Press and release the first key to be learned, the indicator light will now flash slowly. 4. On the original remote, press and hold the key that you want to learn to the corresponding key previously pressed on the RRST01.2.
Page 4 RRST01.2 indicator light flashes three times and then remains on. Press & keys to save and exit. The key is now programmed to the RRST01.2 and should operate your unit. Still having trouble, please visit Anderic.com/RRST01 for a step-by-step video.