Table of Contents
Advertisement
3.3 Unpacking instructions
Locate the identification sticker at the back of the product and ensure that the product you
have received is the appropriate one.
Important information is on this sticker; such as the power consumption rating and the type
name and serial number that you will need for any kind of correspondence with Epson.
3.4 Installation and storage environment
3.4.1 Installation environment
The IF-240 can be used under the following conditions:
- The IF-240 is IP20 compliant
- Working temperature: + 5°C to + 40°C
- Humidity: 30% to 80%max. non-condensing
- Avoid extreme electromagnetic waves, ultraviolet rays and radiation.
- Avoid using the product in a place where the main unit or controller may be exposed to
- Clean room application: cleanliness class ISO7.
Part Feeding 7.0 IF-240 Rev.5
Do not remove the part feeder from its packaging until you are
NOTE
ready to install it.
Keep the packaging material and the shipment box in case of
need for return.
WARNING
- The IF-240 must be mounted on a smooth, flat and solid
surface. Ensure that the IF-240 is not submitted to mounting
flexure. Failure to do so will degrade feeder performance.
- Be careful not to get hands or feet caught and/or have
WARNING
equipment damaged by a fall of the feeder. When working,
please wear protective equipment including safety shoes.
In the case of humidity or temperature variation, note that it
might affect the global performances of the part feeder.
WARNING
water or oil droplets.
Do not use the product in an atmosphere of corrosive gases.
Rust may form and reduce the structural strength of the
product.
WARNING
3. Transportation, handling, and installation
23
Advertisement
Table of Contents
