Advertisement
Fixing kit cont..
39
2x Door Handles
PI-07-0001
40
Mortice Lock
PI-07-0017
12x Butt Hinge
41
PI-07-0066
42
Key Plate
PI-07-0017
4x Turn Button
43
PI-07-0034
Pre Assembly
Before assembling remove the transportation
blocks from the bottom of each panel.
Step 1
Place the 2 oor panels (No. 13) onto a rm
and level base , ensuring the
base has suitable drainage & is free from
areas where standing water can collect.
Secure the oors together using the
Floor Blocks (No.22) and 10x30mm
screws per oor.
Once tted, turn the oor assembly the
right way up.
20x30mm Screws
30mm
Pre drill
screw
hole
Nail Bag
PI-02-0352
70mm Screw x 13
50mm Screw x 132
30mm Black Screw x 4
30mm Screw x 168
10mm Screw x 8
Felt Tacks x 199
13
13
22
Please retain product label and instructions for future reference
*This building can be built with the shed on the LEFT hand side. Follow the
same steps but be aware to position panels to the opposite side.*
Step 2
Flip the assembled Floor (No. 6) over and Place
the small oor (No. 14) ush against
the assembled oor.
Using 4x50mm screws x the small oor in
place as shown in the diagram.
4x50mm Screws
50mm
Pre drill
screw
hole
Step 3a
Assembly of the main door and the
storage door.
Lay each door (No. 16, No. 17, No. 17b
and No. 18) at on a level surface, place a
hinge at the top, middle and bottom of
the door and x each hinge (No. 40) into
place using three 30mm screws, ensure
to pre-drill the holes rst. Position the
hinges as shown in the diagram (only
two doors have been shown in the
illustration) to ensure that they are in the
correct place before attaching the doors
to the door panel.
Place the door panels (No. 1 and No. 6)
at on the ground and the doors within
the aperture. Position the doors equally
within the space and then using 30mm
screws secure the doors in place.
72x30mm Screws
30mm
Pre drill
screw
hole
6
14
6
16
18
40
1
6
16
17
17b
17
18
16
17b
18
P 3
Advertisement
