Fujitsu ARXG24KMLA Design & Technical Manual page 110

¢ Peak cut mode
1. Press the MODE switch button (S134) for 3 seconds or more to switch to "Local setting mode".
2. After confirming the LED lamp of POWER/MODE blinks 9 times, press the ENTER switch but-
ton (S132).
3. Press the SELECT switch button (S133), and adjust the LED lamp as shown below. Then the
LED lamp indicates the current setting.
4. Press the ENTER switch button (S132).
5. Press the SELECT switch button (S133), and adjust the LED lamps as shown below.
6. Press the ENTER switch button (S132) and fix it.
7. To return to "Operating status display (Normal operation)", press the EXIT switch button
(S131).
NOTE: When pressed number is lost during setting, you must redo the setting procedure. Return to
"Operation status display (Normal operation)" by pressing the EXIT switch button once, and
restart from the beginning of the setting procedure.
13-2. Local setting procedure
PUMP
POWER
LOW NOISE
DOWN
ERROR
MODE
(L1) (L2)
Blinks
)
(9 times
Sign " ": Lights off
PEAK CUT
E
MOD
PEAK CUT
MODE
0 % of rated input ratio
50 % of rated input ratio
75 % of rated input ratio
100 % of rated input ratio
0 % of rated input ratio
50 % of rated input ratio
75 % of rated input ratio
100 % of rated input ratio
- 104 -
PEAK CUT
(L3) (L4) (L5) (L6)
LOW NOISE
(L2) (L3)
Blink
LOW NOISE
(L2) (L3)
Sign " ": Lights on
PEAK CUT
(L4) (L5) (L6)
Blink
Blink
Blink Blink
Blink
PEAK CUT
(L4) (L5) (L6)
13. Function settings (30-45 models)