Programme Cancellation And Error Message - Miele PWM 307 Operating And Installation Instructions

Programme cancellation and error message

Problem

Drainage fault. Clean
drain filter and pump.
Check the drain
hose.

Water intake fault.
Open stopcock.

Waterproof system
activated

Fault F . If restart
fails, call Service
Cause and remedy
The drain is blocked or restricted.
The drain hose has been fixed too high.
 Clean the drain filter and the drain pump.
 The maximum drain height is 1 m.
The water inlet is blocked or restricted.
 Check whether the stopcock has been properly
opened.
 Check whether the inlet hose is kinked.
The water pressure is too low.
 Switch on the
water pressure" under "Supervisor level").
The filters in the water inlet are blocked.
 Clean the filters (see "Cleaning the filters" under
"Cleaning and care").
The water protection system has reacted.
 Close the stopcock.
 Call Miele Service.
There is a fault.
 Disconnect the washing machine from the electri-
city supply.
 Wait at least 2 minutes before reconnecting the
washing machine to the electricity supply.
 Switch the washing machine on again.
 Start the programme again.
If the fault message appears again, contact Miele
Service.
Problem solving guide
Low water pressure setting (see "Low
43