Alcatel-Lucent OmniSwitch 6850-48 Hardware User's Manual page 71

OmniSwitch 6850 Series Chassis and Hardware Components
Refer to the illustration below for more front panel information. For detailed LED descriptions, refer to
page 2-54. For information on the chassis rear panel, refer to
USB Port
High speed USB 2.0 port, which
can be used for quick upgrades.
OK PRI PWR BPS
OmniSwitch 6850-P24X 1 2
USB
25 26
25
26
CLASS 1 LASER PRODUCT
Console
Console Port
The OS6850-P24X front panel
provides one RJ-45 port for con-
sole connections. Console con-
nections are used by network
administrators for switch man-
agement. This female RJ-45 con-
nector provides a DTE console
connection.
OmniSwitch 6850 Series Hardware Users Guide
10/100/1000Mbps PoE
The OS6850-P24X provides 20 fixed 10/100/
1000BaseT non-combo PoE (1–20) and 4 fixed
10/100/1000BaseT combo PoE (21–24). These
are auto-sensing and auto-MDIX and use RJ-45
connectors.
3 4 5 6 7 8 9 10 11 12 13 14 15 16
XFP
The OS6850-P24X front panel pro-
vides two for 10 Gbps Small Form
Factor Pluggable (XFP) transceiv-
ers.
OmniSwitch 6850-P24X Front Panel
September 2009
page 2-56.
Status and Slot Indicator LEDs
For information on the OS6850-P24X's
status and slot indicator LEDs, refer to
page
17 18 19 20 21 22 23 24
21 22 23 24
CLASS 1 LASER PRODUCT
Combo SFP
The OS6850-P24X provides four combo
SFP connectors for 1000Base-X high-
speed connections
By default, when an SFP is installed in a
combo port, it takes over the port number
of the corresponding RJ-45 Ethernet port.
In other words, if an SFP is installed in
the slot labeled 24, Ethernet port 24
would no longer be available and cannot
be used for 10/100/1000 traffic. This
default setting is referred to as "preferred
fiber." Refer to "Configuring Ethernet"
in the Network Configuration Guide for
detailed information, including steps for
configuring combo port settings.
OmniSwitch 6850-P24X
2-54.
.
page 2-47