Aiwa CSD-SL10 Operating Instructions Manual

I
I
I
I
I
I
I
1
I
I
I
I
I
I
I
I
i
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
1'
I
I
1.
1"
I
I
I
I
I
I
I
I
I
anua
COMPACT DISC STEREO
M3=SLIOU
RADIO CASSETTE RECORDER
~~1~
DIGITALAUDIO
r I
>,
I The Operating Instructions are divided into 3-language sections.
I
OPERATING INSTRUCTIONS ~
Please remove the irrelevant language section by cutting along the dotted lines.
WARNING
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
~
p!-! ~
'(CAUTION:TO REDUCE THE RISK OF
ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE,
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL,"
Explanation of Graphical Symbols:
/4/
The lightning flash with arrowhead symbol,
within an equilateral triangle, is intended to
alert the user to the presence of uninsulated
"dangerous voltage" within the product's
enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to
persons.
A
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
Owner's record
For your convenience, record the model number and serial
number (you will find them on the rear of your set) in the
space provided below. Please refer to them when you contact
your Aiwa dealer in case of difficulty.
Model No. Serial No. (Lot No.)
NOTE
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna,
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio~V
technician for help.
CAUTION
Modifications or adjustments to this product, which are not
expressly approved by the manufacturer, may void the user's
right or authority to operate this product.
Specifications
Tuner section
Frequency range, antenna — FM: 87.5 -108,0 MHz Rod antenna,
AM: 530-1,710 kHz Ferrite bar antenna
Deck section
Track format — 4 tracks, 2 channels/ Frequency range — Normal tape:
50-12,500 Hz (EIAJ) / Recording system — AC bias/ Erasing system —
Magnet erase / Heads — Recording/playback head(1), Erasure head(1)
CD player section
Disc — Compact disc/ Scanning method — Non-contact optical scanner
(semiconductor laser)
General
Speaker — 100 mm cone type (2), 75 mm cone type (2)/ Output —
Headphones jack (stereo mini-jack) / Power output — 2 W + 2 W (EIAJ
8 ohms DC)/ Power requirements — DC 12 V using eight size C (R14)
batteries, AC 120 V, 60 Hz/ Power consumption — 12 W / Dimensions —
410 (W) x 191.7 (H) x 142 (D) mm (161/4x 75/8x 55/t3in.) / Weight —
3.2 kg (7 Ibs. 1 OZ)(excluding batteries)
Precautions
Read the Operating Instructions carefully and completely
before operating the unit, Be sure to keep the Operating
Instructions for future reference. All warnings and cautions in
the Operating Instructions and on the unit should be strictly
followed, as well as the safety suggestions below,
Installation
1
2
3
4
5
6
7
8
Water and moisture - Do not use this unit near water,
such as near a bathtub, washbowl, kitchen sink, laundry
tub, in a wet basement, swimming pool, or the like,
Heat - Do not use this unit near sources of heat, including
heating vents, stoves, or other appliances that generate
heat.
It also should not be placed in temperatures less than 5°C
(41 'F) or greater than 35°C (95°F).
Mounting surface - Place the unit on a flat, even surface.
Ventilation - The unit should be situated with adequate
space around it so that proper heat ventilation is assured.
Allow 10 cm (4 in.) clearance from the rear and the top of
the unit and 5 cm (2 in.) from each side,
- Do not place the unit on a bed, rug, or similar surface that
may block the ventilation openings.
- Do not install the unit in a bookcase, cabinet, or airtight
rack where ventilation may be impeded.
Objects and liquid entry - Take care that objects or
liquids do not get inside the unit through the ventilation
openings.
Carts and stands - When placed or
mounted on a stand or cart, the unit should
be moved with care.
Quick stops, excessive force, and uneven
surfaces may cause the unit or cart to
overturn or fall,
Condensation - Moisture may form on the CD pickup lens
when:
- The unit is moved from a cold spot to a warm spot
- The heating system has just been turned on
- The unit is used in a very humid room
- The unit is cooled by an air conditioner
When this unit has condensation inside, it may not function
normally. Should this occur, leave the unit for a few hours,
then try to operate again.
Wall or ceilina mounting - The unit should not be
mounted on a-wall or ceiling, unless specified in the
Operating Instructions.
Electric Power
1
2
3
4
5
Power sources - Use on batteries or AC house current, as
specified in the Operating Instructions and marked on the
unit.
Polarization - As a safety feature, some units are
equipped with polarized AC power plugs which can only be
inserted one way into a power outlet. If it is difficult or
impossible to insert the AC power plug into an outlet, turn
the plug over and try again. If it still does not easily insert
into the outlet, please call a qualified service technician to
service or replace the outlet, To avoid defeating the safety
feature of the polarized plug, do not force it into a power
outlet.
AC power cord
- When disconnecting the AC power cord, pull it out by the
AC power plug. Do not pull the cord itself.
- Never handle the AC power plug with wet hands, as this
could result in fire or shock.
- Power cords should be firmly secured to avoid being
bent, pinched, or walked upon. Pay particular
attention to the cord from the unit to the power socket.
- Avoid overloading AC power plugs and extension cords
beyond their capacity, as this could result in fire or shock.
Extension cord - To help prevent electric shock, do not
use a polarized AC power plug with an extension cord,
receptacle, or other outlet unless the polarized plug can be
completely inserted to prevent exposure of the blades of
the plug,
When not in use - Unplug the AC power cord from the AC
power socket or remove a~lthe batteries if the unit will not
be used for several months or more. When the cord is
plugged in, a small amount of current continues to flow to
the unit, even when the power is turned off.
Maintenance
Clean the unit only as recommended in the Operating
Instructions.
Damage Requiring Service
Have the units serviced by a qualified service technician if:
- The AC power cord or plug has been damaged
- Foreign objects or liquid have got inside the unit
- The unit has been exposed to rain or water
- The unit does not seem to operate normally
- The unit exhibits a marked change in performance
- The unit has been dropped, or the cabinet has been
damaged
DO NOT ATTEMPT TO SERVICE THE UNIT YOURSELF.
Power Supply
FUNCTION OPE/BATT
E
""00
' ~~
,%==1 '
IMPORTANT
Make sure that FUNCTION is set to POWER (!) STANDBY/
TAPE before connecting the AC cord or inserting batteries,
Using on AC house current
Connect the AC cord as illustrated below.
to the AC inlet of the unit
supplied AC cord
CAUTION
Use only the supplied AC
result in the risk of fire.
L.
~ to an AC outlet
oord. Use with other cords may
Using on batteries ' '
.,
Open the lid of the battery compartment on the rear and insert
eight RI 4 (size C) batteries, not supplied, as illustrated below.
Then close the lid.
Before using on batteries, disconnect the AC cord from the
AC inlet. Battery power is cut off automatically when the cord
is connected.
The batteries need to be replaced when:
The OPE/BATT indicator becomes dim, the tape speed slows
down, volume decreases, or sound is distorted during
operation.
Notes on batteries
To avoid damage from leakage or explosion, observe the
following:
c Insert the batteries with the () and O marks correctly
aligned.
Do not mix different types of batteries or old batteries with
new ones.
Never recharge the batteries, apply heat to them or take
them apart.
Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to remove.
Specifications and external appearance are subject to change without
notice.
87-CD4-905-01
970318 BA0-~X
Printed in China
AIWA CO.,LTD.
1