Establishing the link
Testing
Dimensions and drilling plan
Siemens
Building Technologies
1.
Press the button on the radio module for at least
8 seconds until the LED on the radio module
starts flashing at high frequency.
2.
Press the button on the transmitter of the wireless
outside sensor for at least 8 seconds until that
LED also starts flashing at high frequency.
3.
The link is established when the LED on the radio
module extinguishes.
4.
Press the button on the transmitter of the wireless outside sensor briefly again
until the LED extinguishes.
The test is made to check the quality of the radio link.
· The test can be stopped by pressing the ESC button
· While the radio link can be opened on the boiler, the test should be made at the
location where the room unit will be installed
1. Press button on the transmitter of the wireless outside sensor 3 to at most 8
seconds until the LED start flashing at low frequency.
2. When radio communication works, the LED on the radio module flashes briefly
at 10-second intervals.
3. After the test, press the button on the transmitter of the wireless outside sensor
again briefly until the LED extinguishes.
90
4,2
2
1
56
60
User Manual
3 Mounting and installation
79,8
32
Button
49,7
5,5
3
Ø 14,1
24,5
25
49,5
CE1U2357en
2014-07-30
LED
27/109