Advertisement
Description of Parts – Speaker Front & Accessories
Before the first time you use your Party Speaker
Please read these operating instructions thoroughly and keep them in a safe place for future
reference.
Remove all packing materials and discard responsibly.
Charging the internal Battery
Before use, please ensure that the internal rechargeable battery is fully charged as follows:
1. Insert the DC Plug (22) of the USB Charging Cable (20) into the DC 5V in
Charging Socket (2) on the top panel of the speaker to charge the internal
battery.
2. Insert the USB plug (21) of the USB Charging Cable (20) into a suitable
USB charger rated at 2 amp minimum.
3. The LED Indicator (16) will light red to show the internal battery is
charging. Once the battery is fully charged (after approximately 6 hours),
the LED Indicator (16) will go out showing that the internal battery is fully
charged and the USB Charging Cable (20) can be removed.
NB the speaker can be used normally during charging. Also, once fully
charged, the speaker will operate for up to 3 hours on its internal battery.
During use, if the speaker gives a beep tone, this indicates the internal battery is low on
charge and will need recharging. Follow the procedure above to recharge the battery.
Using the Bluetooth Mode
1. Switch on the speaker by pressing the Power On/Off switch (3) on the
top panel (arrowed right).
2. The LED Display (2) on the top panel will flash the word 'blue' to indicate
that it is ready to pair with an external Bluetooth device as below:
IMPORTANT – RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
17. Loudspeaker(s)
18. LED Lighting Effect(s)
19. 3.5mm Jack to Jack lead (a 3.5mm Jack to
Jack Lead is supplied but an appropriate
lead maybe required to suit the external
17
equipment used.)
20. USB Charging Cable
18
21. USB Plug
22. DC Plug
18
17
LED Bluetooth Party Speaker
User Manual
19
22
AVS1449
20
21
5
Advertisement
