Page 1
For your convenience, record the model number and serial number (you will find them on the rear of your set) in the space provided below. Please refer to them when you contact your AIWA dealer in case of difficulty. Model No. ADC-M105 Serial No.
Welcome Thank you for your purchasing this AIWA product. To optimize the performance of this unit, please read through this manual carefully. TABLE OF CONTENTS FEATURES ... 1 PRECAUTIONS ... 2 UNPACKING ... 3 INSTALLATIONS ... 4 CONNECTIONS ... 8 HOW TO USE ...
PRECAUTIONS • Do NOT install the unit in a location where it may be subjected to: — Direct sunlight or other sources of excessive heat — Fluid, rain or moisture — Excessive dirt or dust — Excessive vibration • This unit is designed to be operated on a 12-volt DC negative-ground electrical system only.
UNPACKING Compact disc changer Compact disc magazine Connecting cable Supplied mounting kit for the compact disc changer The letters are keyed to those in the instructions. Use only the supplied mounting hardware for safe and secure installation. a Brackets (1 pair) b Washer screws c Plate brackets d Nuts (4 ea.)
INSTALLATIONS Precautions Select the mounting location very carefully, referring to the following points. • Make sure that there is no fuel tank, wiring or piping on the other side of the mounting surface. • Make sure that the installation of the unit will not hinder the movement of the deck lid or interfere with the spare tire, etc.
Page 6
INSTALLATIONS Horizontal installation Construction For details on abc..., see page 3. Note If the mounting surface needs to be strengthened, secure the plate brackets c to the bottom surface of the car trunk, etc. with the tapping screws (not supplied). Deciding the position Removing temporarily ENGLISH...
Page 7
Vertical installation Construction For details on abc..., see page 3. Notes • If the mounting surface needs to be strengthened, secure the plate brackets c to the bottom surface of the car trunk, etc. with the tapping screws (not supplied). Deciding the position Removing temporarily The effective angle of...
Page 8
INSTALLATIONS Suspended installation When installing the unit in the trunk below the package tray, observe the following. • Select the mounting location carefully so that the unit does not hinder the movement of the torsion bars of the deck lid. Construction For details on abc..., see page 3.
CONNECTIONS This unit is designed only for AIWA brand car stereo. Therefore you cannot use the unit with other brand’s equipment. Compact disc changer Caution Be sure to disconnect the ground wire terminal of the car battery before making a connection in order to prevent short circuiting.
HOW TO USE How to use a compact disc magazine With the label side up, insert a disc all the way. 10 discs, one in each disc tray Open the door. Disc magazine Insert the magazine (which has been taken out of the unit) firmly with the on the top side.
Notes on the disc magazine • Be sure to place a disc on the disc tray with the label side up. If a disc is not set properly, it may cause damage to the unit. Disc magazine Disc tray • The disc tray may be taken off from the magazine if you pull the tray forcibly.