Aiwa XP-SP30 Operating Instructions

Portable CD Player

Operating Instructions

XP-SP30
©2003 Sony Corporation
1 s(stop)/CHARGE
2 ca* (play/pause)/ENTER
\ (headphones) jack
DC IN 4.5 V (external power
input) jack
* The button has a tactile dot.
Display
Sound mode
CHG Track number
Remaining battery power
A
Open the battery Insert the ( end first
compartment lid. (for both batteries).
C
to \
to DC IN
4.5 V
to an AC outlet
Headphones
AC power
adaptor
E
Labeled side up
http://www.aiwa.com/
Printed in China
3 r/t (skip/search)
4 SOUND
5 PLAY MODE/
OPEN/LOCK knob
6 VOLUME +*/–
7 HOLD
Play mode
Playing time
B
D
The OPEN arrowhead
should be beyond the
OPEN
dotted line of the above
figure.
F
The LOCK arrowhead
should be beyond the
LOCK
dotted line of the above
figure.
WARNING
3-257-258-11 (1)
To prevent fire or shock hazard, do not expose the AC
power adaptor to rain or moisture.
Do not install the appliance in a confined space, such as
a bookcase or built-in cabinet.
To prevent fire, do not cover the ventilation of the
apparatus with newspapers, tablecloths, curtains, etc.
And don't place lighted candles on the apparatus.
To prevent fire or shock hazard, do not place objects filled
with liquids, such as vases, on the apparatus.
CAUTION
The use of optical instruments with this product will
increase eye hazard.
Certain countries may regulate disposal of the battery used
to power this product. Please consult with your local
authority.
CAUTION
• INVISIBLE LASER RADIATION WHEN OPEN
• DO NOT STARE INTO BEAM OR VIEW DIRECTLY
WITH OPTICAL INSTRUMENT
The validity of the CE marking is restricted to only those
countries where it is legally enforced, mainly in the
countries EEA (European Economic Area).
Owner's Record
The model number is located at the rear and the serial
number is located inside the lid of the CD player. Record
the serial number in the space provided below. Refer to
them whenever you call upon your Aiwa dealer regarding
this product.
Model No. XP-SP30
Serial No. ______________________________________
For the customers in the USA
(repeat)
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your
8 E•A•S•S GP authority to operate this equipment.

Power sources

Usable batteries
Use only the following batteries for your CD player:
Dry batteries
• LR6 (size AA) alkaline batteries (not supplied)
Rechargeable batteries
Charge the rechargeable batteries before using them for
the first time.
• Commercially-available size AA Ni-MH rechargeable
batteries of 1.2 V DC, 700 mAh
To insert the batteries (A)
1
Turn the OPEN/LOCK knob fully to OPEN until it
stops and open the lid (D).
2
Open the battery compartment lid inside the CD player.
3
Insert two batteries by matching ) to the diagram in
the battery compartment and close the lid of the
battery compartment until it clicks into place.
To charge the rechargeable batteries
1
After inserting the rechargeable batteries in the
battery compartment, connect the AC power adaptor
to the DC IN 4.5 V jack and an AC outlet (C).
2
Press s/CHARGE.
The CD player starts charging.
The "CHG" indicator turns on in the display and the
indicator sections of
When the batteries are completely charged, the
"CHG" and
If you press s/CHARGE after the charge has already
been completed, the
"Full" appears in the display.
3
Disconnect the AC power adaptor.
To remove the batteries (B)
Press down the ( side of the batteries and remove them.
To check the remaining power of the
batteries
You can check it in the display.
Replace the batteries when "
"Lo batt"*
* Beep sounds only when the CD player is set to emit beep.
See "To turn off the operation beep sound" on the reverse
side.
Notes
• The indicator sections of
remaining battery power. One section does not always
indicate one-fourth of the battery power.
• Depending on operating conditions, the indicator
sections of
Battery life* (approx. hours)
(When the CD player is used on a flat and stable place.)
Playing time varies depending on how the CD player is used.
Two Sony alkaline
batteries LR6 (SG)
(produced in Japan)
* Measured value by the standard of JEITA (Japan Electronics
and Information Technology Industries Association)
Notes on using the dry batteries
• Be sure to remove the AC power adaptor.
• When the batteries are depleted, replace both batteries
with new ones.
To use the AC power adaptor
Connect the AC power adaptor to an AC outlet (C).

Playing a CD

To insert a CD
1
Turn the OPEN/LOCK knob fully to OPEN until it
stops and open the lid (D).
2
Fit the CD to the pivot and close the lid (E).
3
Turn the OPEN/LOCK knob fully to LOCK until it
stops to fasten the lid securely (F).
Notes
• This CD player can play discs recorded in the Compact
Disc Digital Audio (Audio CD) format.
• This CD player can play CD-Rs/CD-RWs recorded in the
Compact Disc Digital Audio (Audio CD) format, but
playback capability may vary depending on the quality of
the disc and the condition of the recording device.
• This product is designed to play back discs that conform
to the Compact Disc (CD) standard. Recently, various
music discs encoded with copyright protection
technologies are marketed by some record companies.
Please be aware that among those discs, there are some
that do not conform to the CD standard and may not be
playable by this product.
To operate the CD player
Button/Switch
1 s(stop)/
CHARGE
2 ca(play/pause)/
ENTER
3 r/t
(skip/search)
4 SOUND
5 PLAY MODE/
light up in succession.
indicators get turned off.
indicator flashes and
6 VOLUME +/–
7 HOLD
8 E•A•S•S GP*
1
* If the sound is distorted when using the SOUND function,
turn down the volume.
2
* See "The E•A•S•S GP function" on the reverse side.
" flashes.
roughly shows the
may increase or decrease.
E•A•S•S GP
ON OFF
50 40
Function/Operation
Press to stop playing. Press also to
start charging.
Press to start playing. Press again
to pause playing.
To play from the first track, press
for 2 seconds or more while the
CD player is stopped.
Press to enter the selected track
for the PGM play.
Press r or t once to find
the beginning of the current/next
track. Press r or t
repeatedly to find the beginning of
the previous/succeeding tracks.
Press and hold r or t to go
backward/forward quickly.
Use to emphasize the bass-boosted
sound. Press repeatedly to select
or .
enhances more than
1
.*
Press repeatedly until the play
(repeat) mode you want appears in the
display.
No indication: Normal play
"1": Single play
"SHUF": Shuffle play
"PGM": PGM (program) play
To repeat the play mode you
selected, press and hold until
" " appears. To cancel it, press
and hold again until " "
disappears.
Press repeatedly to adjust the
volume.
Set to ON to lock the controls on
your CD player to prevent
accidental button presses.
2
Set to ON to protect against sound
skipping.
(Continue to the reverse side)