Configure a Beacon 6 (HA-0336W-B)
Connection Type
Connection Mode
IP Mode
Enable/Disable
NAT
Service
Enable VLAN
VLAN ID
VLAN PRI
WAN IP Mode
Address Method
Enable Prefix Delegation
Prefix Type
Field
WAN Connection List
(1)
Connection Mode
Enable/Disable
Service
Enable VLAN
VLAN Mode
LAN port binding
SSID port binding
Notes
(1)
A warning pop-up message is displayed when Bridge mode is selected: "Please remove and re-insert the cables connected to the LAN ports.
Reconnect to the SSIDs associated to the bridge WAN. Make sure that the extension beacons are not connected to the LAN ports
associated to the bridge WAN." You can then accept or cancel the operation.
2
Configure a specific WAN connection.
72
Select a connection type: IPoE or PPPoE
Choose the connection mode from the drop-down menu; either Route mode or
Bridge mode
Choose an IP mode from the drop-down menu: IPv4 or IPv6
Select this checkbox to enable the WAN connection
Select this checkbox to enable NAT
Select the checkboxes to enable service types for this connection
Select this checkbox to enable VLAN
Enter the VLAN ID
Enter the VLAN PRI
Choose an IP mode from the drop-down menu
Choose the address method from the drop-down menu
Select the checkbox to enable prefix delegation
Choose the prefix type from drop-down menu
Table 21
WAN parameters - Bridge Mode
Description
Choose a WAN connection from the drop-down menu to set the connection
parameters
Choose the connection mode from the drop-down menu; either Route mode or
Bridge mode
Select this checkbox to enable the WAN connection
Select the checkboxes to enable service types for this connection
Select this checkbox to enable VLAN
Choose a VLAN mode from the drop-down menu
Select the checkbox(es) to bind selected LAN ports to the WAN connection
Select the checkbox(es) to bind selected SSID ports to the WAN connection.
The options are SSID ports 2, 3, 4, and 6-8; SSID ports 1 and 5 cannot be
selected and are therefore grayed out.
3FE-47429-AAAA-TCZZA
Nokia WiFi Beacon 6 Product Guide
Issue: 01