Craftsman 315.BT2010 Operator's Manual page 14

WORK CLAMP
See Figure 10.
The work clamp provides greater control by clamping the
workpiece to the fence. It also prevents the workpiece
from creeping toward the saw blade. This is very helpful
when cutting compound miters.
Depending on the cutting operation and the size of the
workpiece, it may be necessary to use a C-clamp instead
of the work clamp to secure the workpiece prior to making
the cut.
WARNING:
In some operations, the work clamp
assembly may interfere with the operation of the
blade guard assembly. Always make sure there is no
interference with the blade guard prior to beginning
any cutting operation to reduce the risk of serious
personal injury.
To install the work clamp:
 Place the shaft of the work clamp in either hole on the
saw table base.
 Rotate the knob on the work clamp to move it in or out
as needed.
ASSEMBLY
BASE
14 — English
WORK
CLAMP
Fig. 10