Antenna Patterns In The Etsi Frequency Band - Siemens SIMATIC Ident RF622A ETSI Operating Instructions Manual

Table of Contents

Advertisement

Antenna patterns

5.2 Antenna patterns in the ETSI frequency band

5.2
Antenna patterns in the ETSI frequency band
Directional radiation pattern ETSI
The directional radiation pattern is shown for nominal alignment and a center frequency of
866.3 MHz. The nominal antenna alignment is given when the antenna elevation is provided
as shown in the following figure.
Figure 5-4
Alignment and reference system of the antenna
The half-power beamwidth of the antenna (opening angle) is defined by the angle between
the two -3 dB points (corresponding to half the power referred to the maximum power). The
range (in %) corresponding to the dB values in the patterns can be obtained from the table in
the section "Interpretation of directional radiation patterns (Page 24)".
Note that the measurements presented graphically below were carried out in a low-reflection
environment. Deviations can therefore occur in a normally reflecting environment.
18
Operating Instructions, 11/2020, C79000-G8976-C601-01
SIMATIC RF622A

Advertisement

Table of Contents
loading

This manual is also suitable for:

Simatic ident rf622a fcc6gt2812-2ea006gt2812-2ea01

Table of Contents