Display Selection - Honeywell IntuVue RDR-4000 Pilot's Manual

IntuVue RDR-4000 Weather Radar Pilot's Guide

DISPLAY SELECTION

D201002000008
Rev 1, December 2014
OFF – When the Display Selection Knob is in the
OFF position, no radar display is shown. If a
windshear event should occur, the ALL/ALL WX
weather mode will be shown, with the windshear
icon(s) overlaid. When it is not safe to transmit,
select OFF on both Display Selection Knobs to
prevent the radar from transmitting.
ALL or ALL WX – Automatic Weather Mode. Both
On Path and Off Path weather are shown. Off Path
weather returns are shown with black stripes through
them. This mode provides display of windshear out
to 5 nm, turbulence out to 40 nm and weather out to
320 nm.
ON PATH or PATH WX – Automatic Weather Mode.
Only On Path weather is shown (Off Path weather is
suppressed). This mode provides display of
windshear out to 5 nm, turbulence out to 40 nm (or
60 nm for PATH WX) and weather out to 320 nm.
ELEVN – Constant Elevation (Weather Analysis
Mode). Only weather at the selected elevation is
shown. The elevation slice defaults to current altitude
upon initial selection. The displayed elevation can be
moved up or down in 1,000-foot increments using the
Elevation Control Knob. This mode provides display
of windshear out to 5 nm and weather out to 320 nm.
Turbulence data is not shown in this mode.
MAP – Displays Full Coverage Ground Map. If a
windshear event should occur, the ALL or ALL WX
weather mode will be shown, with the windshear
icon(s) overlaid.
Equipment Description
31