Table of Contents
Advertisement
Setting Up
Connecting the Main Unit to Input Devices
The video display has SDI and HDMI input terminals to connect input devices.
CAUTION
14
• Check that the power to the video display and input devices is switched off before connecting an input device to this display's SDI
or HDMI input terminal.
• Use a HDMI cable with the High Speed logo that complies with the HDMI standard. When a non-compliant HDMI standard cable
is used, the video display may not work normally, for example, video becomes choppy or nothing is displayed.
Reference
• The connection is tested using D5.5UHDC03E BNC cables manufactured by Canare Electric Co.
• When 3G-SDI RAW signal frequency exceeds 30.00P, it becomes a dual connection.
• Each input terminal is compatible with through output. When signals are input from Input (IN) A, connect the cable to the SDI (OUT)
terminal of Input A.
■ Signals that can be connected to the SDI input terminal
Quad Link
(Square Division)
Quad Link
(2 Sample Interleave)
Dual Link
Single Link
Input signal
12G/6G/3G/
Top left, Mapping signal
HD-SDI
Top right, Mapping signal
Bottom left, Mapping signal
Bottom right, Mapping signal
3G-SDI
6G/3G-SDI
12G/6G/3G/HD/
SD-SDI
SDI input terminal
HDMI input terminal
Input terminal
Input A
Input B
Input C
Input D
Link 1
Input A
Link 2
Input B
Link 3
Input C
Link 4
Input D
Link 1
Input A
Link 2
Input B
Link 1
Input C
Link 2
Input D
Input A/Input B/
—
Input C/Input D
Single input system
Single input system
Two input systems
Four input systems
Advertisement
Table of Contents
