D-Link COVR User Manual page 46

Hide thumbs Also See for COVR:
Table of Contents

Advertisement

Section 3 - Configuration
DHCP Server
Status:
Enable or disable the DHCP server.
DHCP IP Address
Enter the starting and ending IP addresses for the DHCP server's IP
Range:
assignment.
Note: If you have reserved static IP addresses to client devices, make
sure the IP addresses are outside of this range or you might have an IP
conflict. Refer to Connected Clients section 14 for how reserve IP
addresses for clients.
DHCP Lease Time:
Enter the length of time for the IP address lease (in minutes).
Always Broadcast:
Enable this feature to broadcast your network's DHCP server to LAN/
WLAN clients.
Advanced Settings
WAN Port Speed:
You may set the port speed of the Internet port to 10 Mbps, 100
Mbps, 1000 Mbps, or Auto (recommended).
UPnP:
Enable or disable Universal Plug and Play (UPnP). UPnP provides
compatibility with networking equipment, software, and peripherals.
IPv4 Multicast
Enable to allow IPv4 multicast traffic to pass through the master COVR
Streams:
Point from the Internet.
Click Save when you are done.
D-Link COVR-1102 User Manual
Network (Continued)
42

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Covr-1100Covr-1102Covr-1103Covr series

Table of Contents