Page 1
Operation Manual Aquarium Vibration Pump Wave Maker CW-110, CW-120, CW-140, CW-160 51656–51659 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignific - antly.
Page 2
The information contained in this document may alter at any time without previous notice. It is prohib- ited to copy or spread any parts of this document in any way without prior written allowance. All rights reserved. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
Page 3
Introduction Thank you for purchasing this quality product. To minimize the risk of injury we urge that our cli- ents take some basic safety precautions when using this device. Please read the operation in - structions carefully and make sure you have understood its content. Keep these operation instructions safe.
Page 4
Warnings Attention: please make sure that all pump parts are intact before switching on the wave maker. Do not connect it to voltage supply sources whose voltage do not match the one indic- ated on the device. There must be no sand in the pump, otherwise component parts are destroyed. Pump dam - ...
Page 5
Parts liste Rotor cover Magnet holder Bearing Control panel Rotor Adapter Motor Spindle Rear cover O-ring Support Lock Rubber joint ring Setting Clean the aquarium before using the pump. Dirt on the aquarium glass panes prevents a cor - rect installation. If the pump slips off it can damage itself or the glass walls of the aquarium (dirt can impair the grip of the magnet/suction attachments).
Page 6
Ill. 1 Ill. 2 Attention Make sure that the pump does not run dry. Only connect the device to the power supply after installation. The control unit and the mains plug must not come into contact with liquids; hence, a drip loop is absolutely necessary.
Page 7
Key functions: MODE/FEED: With a simple push you get to the selection menu; hold this button down for a longer time to enter feeding mode. NIGHT/LOCK: With a simple push you get into night mode; long press this button to enter lock mode.
When connecting the cable to the socket, there must be a drip loop so that water running down the cable from the aquarium cannot get into the socket. Technical specifications Output Flow rate (l/ Suitable for Model Item number Tension aquariums CW-110 51656 500–4000 50–70cm Power consump- tion: CW-120 51657 700–8000 70–120cm...
Disposal regulations EU guidelines regarding the disposal of scrap electric appliances (WEEE, 2012/19/EU) were imple- mented in the law related to electrical and electronic equipment and appliances. All WilTec electric devices that fall under the WEEE regulations are labelled with the crossed-out wheeled waste bin logo.
Page 10
Serial number 10 Zertifikatnummer N8A 001183 0029 Rev. 00 Certificate 11 Gegenstand der Erklärung WilTec Batterieladegerät CW-110, CW-120 Wavemaker, 100-240V~, 50/60Hz, 10W, 20W, Schutzklasse /Protection class: II, IPX8 Object of the declaration 12 Es wird die Übereinstimmung mit weiteren, ebenfalls für das Produkt geltenden EG Richtlinien erklärt:...
Page 11
1 EG-Konformitätserklärung EC Declaration of Conformity 2 Hiermit erklären wir, dass das nachstehend bezeichnete Gerät in seiner Konzeption und Bauart sowie in der von uns in Verkehr gebrachten Ausführung den grundlegenden Sicherheits- und Gesund - heitsanforderungen der nachfolgende(n) EU-Richtlinie(n) entspricht. Bei einer mit uns nicht abgestim- mten Änderung des Gerätes verliert diese Erklärung ihre Gültigkeit.
Need help?
Do you have a question about the CW-110 and is the answer not in the manual?
Questions and answers