Installation Instructions; How To Adjust Level; Installation Area; Checking Level - LG WT7200C Series Service Manual

Hide thumbs Also See for WT7200C Series:
Table of Contents

Advertisement

2. INSTALLATION INSTRUCTIONS

2-1. HOW TO ADJUST LEVEL

Installation area

1
Install the washer on a firm, flat
surface.
If the washer is installed on an
unsuitable floor, it could make
considerable noise and vibrate.
Set Leveling feet
2
Loosen the locknuts on 2 front leveling
feet until you can turn the feet with the
included wrench. Turn clockwise to
raise the washer or counterclockwise
to lower it.
No shims. It would be dangerous. If the
floor is that far from being level, it is a floor
problem and not a washer problem.
CAUTION
‡ The ventilating openings in the base area must not be obstructed by carpeting.
‡ Install the washing machine on a level and firm surface. There should be no more than 1° of variation.
‡ Wooden floors may need reinforcing to prevent the normal vibration which occurs
with an unbalanced load.
‡ Do not install the washer on an inclined floor.
Improper installation of the washer may cause noise and malfunctioning.

Checking level

3
Open the lid, check if the washer is
correctly leveled by looking down
from the top. If the tub is not
centered in the opening, then the
washer is not level.
WRONG
Checking slope
4
If installation surface is tilted, the
washer will vibrate. Do not install
on a sloping floor.
4
RIGHT
Copyright © 2016 - 2017 LG Electronics Inc. All rights
reserved. Only training and service purposes.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents