The Environment; Packing; Use; Cleaning - Electrolux 7GRGDGC0P Manual

Table of Contents

Advertisement

IV. THE ENVIRONMENT

1. PACKING

The packing materials are environmentally friendly
and can be stored without risk or burned in an
appropriate waste incineration plant.
Recyclable plastic components are marked with:
Polyethylene: outer wrapping, instruction booklet
bag, gas nozzle bag.
PE
Polypropylene: roof packing panels, straps.
PP
Polystyrene foam: corner protectors.
PS

2. USE

Our appliances offer high performance and efficiency. To
reduce electricity, water or gas consumption, do not use the
appliance empty or in conditions that compromise optimum
efficiency (e.g. with doors or lids open, etc.); the appliance
must be used in a well-ventilated place, to avoid the creation
of dangerous mixtures of unburnt gases in the room. When
possible, preheat only before use.

3. CLEANING

In order to reduce the emission of pollutants into the environ-
ment, clean the appliance (externally and when necessary
internally) with products that are more than 90% biodegrada-
ble (for further information refer to section V "CLEANING").

4. DISPOSAL

Do not disperse in the environment. Our
appliances are manufactured using more
than 90% (in weight) recyclable metals
(stainless steel, iron, aluminium, galvanised
sheet, copper, etc.).
Make the appliance unusable by removing
the power cable and any compartment or
cavity closing devices (when present) in order to avoid the
risk of someone becoming trapped inside.
V. INSTALLATION
Carefully read the installation and maintenance procedu-
res given in this instruction manual before installing the
appliance.
• Installation, maintenance and conversion to ano-
ther type of gas must only be carried out by qua-
lified personnel authorised by the manufacturer.
Failure to observe the correct installation, conversion and
modification procedures can result in damage to the appliance,
danger to people, and invalidates the Manufacturer's warranty.
1. REFERENCE STANDARDS
• Install the appliance in accordance with the safety regula-
tions and local laws of the country where used.
• AUSTRALIA: this appliance shall be installed only by au-
thorised persons and in accordance with the manufacturer's
installation instructions, local gas fitting regulations, local
water supply regulations, AS5601-gas installation, health
authorities and any other statutory regulations..

2. UNPACKING

ATTENTION!
Immediately check for any damage caused during tran-
sport.
The forwarder is responsible for the safety of the goods
during transport and delivery.
Inspect the packs before and after unloading.
Make a complaint to the forwarder in case of visible or
hidden damage, reporting any damage or shortages on
the dispatch note upon delivery.
The driver must sign the dispatch note: the forwarder can
reject the claim if the dispatch note is not signed (the forwar-
der can provide the necessary form).
• Unpack, taking care not to damage the appliance.
Wear protective gloves.
Carefully remove the protective film from metal surfaces
and clean any traces of glue with a suitable solvent.
For hidden damage or shortages becoming apparent only
after unpacking, request the forwarder for inspection of the
goods within and not later than 15 days of delivery.
Keep all the documentation contained in the packing.

3. POSITIONING

• Handle the appliance with care in order to avoid damage or
danger to people. Use a pallet for handling and positioning.
• The installation diagram provided in this instruction manual
gives the appliance overall dimensions and the position of
connections (gas, electricity, water). Check that they are
available and ready for making all the necessary connections.
• The appliance can be installed separately or combined with
other appliances of the same range.
• The appliances are not suitable for recess-mounting. Le-
ave a space of at least 15 cm between the appliance and
side walls and 20 cm from the rear wall, or in any case an
adequate space to enable subsequent servicing or main-
tenance operations.
• Suitably insulate surfaces that are at distances less than
that indicated.
• Maintain an adequate distance between the appliance
and any combustible walls. Do not store or use flammable
materials and liquids near the appliance.
• Check and if necessary level the appliance after positioning.
Incorrect levelling can cause appliance malfunctioning.
17

Advertisement

Table of Contents
loading

Table of Contents