1. Manuals
  2. Brands
  3. Aaron Manuals
  4. Subwoofer
  5. SW-200
  6. Instructions

Aaron SW-200 Instructions

Aaron sw-200: user guide
Hide thumbs
1
2
3
4

Advertisement

Table of Contents

INSTRUCTIONS
Congratulations on choosing an "Aaron" subwoofer. We at Aaron have gone to the upmost trouble
to ensure your continuing satisfaction for many years to come. Every individual subwoofer unit must
meet our exact specifications with regard to performance and craftsmanship before it is allowed to
leave our factory.

SAFETY INSTRUCTIONS

Make sure the voltage selector is set to your country`s voltage. (Refer Fig. 1).
Always connect the unit to a standard AC wall outlet.
Run the power cord so it will not be damaged by being pinched, stretched, cut or walked on.
Never connect other inputs to the electricity mains.
When removing the power plug don't use wet hands or pull the plug out by the cord.
Remove the power plug from the wall if it is not in use for an extended period. For example when you
go away on holidays.
Whenever changing wires, plugs etc., always have the power turned off.
If water is spilt on the unit always take extreme care to be sure the unit is completely dry before
reconnecting it.
Don't operate the subwoofer too close to heaters.
If the Subwoofer makes a slight distortion noise you have the volume too high and have reached it's
maximum output limit. Please lower the volume control.
Never use more than a small adjustment on your amplifier`s tone controls especially at high volumes.
Turn down the volume when changing a record or switching from one source to another.
Don't push in the speaker diaphragms with any force.
Do not expose the diaphragms to direct sunlight.
It is not advisable to place the unit in a damp environment.
Don't use solvents to clean any part of the unit.
Tampering with the internal parts of the unit may cause an electric shock or damage, not covered by
warranty.
If a part fails, insist on a genuine replacement.
Do not put your ears too close to the speakers or play them too loud for extended period of time as
this may cause partial hearing loss.
Beware! Cats love sharpening their claws on speaker cloth.
When you get your subwoofer check that it has not been damaged in transit. Please keep the original
carton in case of future need, it folds flat and takes up little space.
SUBWOOFER
INSTRUCTIONS
POWERED SUBWOOFER
SW - 200

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SW-200 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Aaron SW-200

Summary of Contents for Aaron SW-200

  • Page 1: Safety Instructions

    INSTRUCTIONS Congratulations on choosing an "Aaron" subwoofer. We at Aaron have gone to the upmost trouble to ensure your continuing satisfaction for many years to come. Every individual subwoofer unit must meet our exact specifications with regard to performance and craftsmanship before it is allowed to leave our factory.

  • Page 2: Subwoofer Placement

    This unit can be placed on its side as well as upright but never place it on it's back or front. Placement can completely alter the sound of your speakers. At Aaron we spend a lot of time and effort to design speakers that are not so position critical, but there will still be some variation from one position to another.
  • Page 3 This input is for connecting to the amplifier`s main speaker outputs. 6: Filtered High Level Output This is for connecting satellite speakers, such as the Aaron SS-120. The output from this connection has a filter which stops frequencies below approximately 80Hz going to the speaker.

  • Page 4: Specifications

    Woofers 460mmH x 315mmW x 445mmD Dimensions Weight NOTE: This model has passed the C-Tick compliance requirements, our supplier code is N1136. Model SW-200 150 watts 0.05% - High 1V - Low 50mV Bass Reflex 1 x 265 mm 23 Kgs...

Table of Contents