Electrolux TT300 Operating And Installation Manual page 20

20
Setup 750/75/650
Unpacking
When unpacking the machine, handle it with
care. There are no transport clamps.
The tumble dryer is fastened to the pallet by
four screws. Remove the two front screws by
opening the filter panel. Remove the two back
screws by unscrewing and removing the bottom
back-plate.
Carefully push the tumble dryer back so that it
1
can be tipped backwards to allow the pallet to
be pulled out from beneath it.
Put the tumble dryer into position, tipping it up
2
to allow the four supplied feet to be fitted.
Positioning
Position the tumble dryer so that there is plenty
of room for working, both for the user and for
the service technician.
The distance from the wall or other equipment
3
behind the tumble dryer should be at least 500
mm and the space at the sides at least 10 mm.
Note that, for servicing purposes, access to the
rear of the tumble dryer is required.
Mechanical installation
Adjust the machine to make it stand horizontally
4
and stably on all four feet.
The max. height adjustment of the feet is 15
mm.
General installation
1
2
3
10
4
487 18 39 01 - 300/500/750 - GB
10